求助：Sun SPARC Enterprise T5220 无法启动
U-Boot 1.1.1 (Jul 29 2008 - 13:10:21)CPU: MPC885ZPnn at 133 MHz: 8 kB I-Cache 8 kB D-Cache FEC present
Board: SPARC885
Watchdog enabled
I2C: ready
DRAM:
trying 128 MBytes
trying 64 MBytes
(64 MB SDRAM) 64 MB
FLASH: 32 MB
In: serial
Out: serial
Err: serial
Net: FEC ETHERNET
POST i2ccd 18 20 23 2a 2d 2e 30 40 43 46 51 53 54 56 68 69 6a 6b 70 71 PASSED
POST cpu PASSED
POST ethernet PASSED
Booting linux in 5 seconds...
## Booting image at fe080000 ...
Image Name: Linux-2.4.22
Image Type: PowerPC Linux Kernel Image (gzip compressed)
Data Size: 814989 Bytes = 795.9 kB
Load Address: 00000000
Entry Point:00000000
Verifying Checksum ... OK
Uncompressing Kernel Image ... OK
do_bootm_linux():
argv=bootm
argv=0xfe080000
## Current stack ends at 0x03D38B70 => set upper limit to 0x00800000
No initrd
## cmdline at 0x007FFF00 ... 0x007FFF80
memstart = 0x00000000
memsize = 0x04000000
flashstart= 0xFE000000
flashsize = 0x02000000
flashoffset = 0x0004C000
sramstart = 0x00000000
sramsize = 0x00000000
EnvAddr = 0xCC33CC33
EnvSize = 0xCC33CC33
sectorsize= 0x00020000
sectorcount = 0x00000100
booted = 0xFE080000
boottype = 0x00000000
primary = 0xFFFFFFFF
pritype = 0x00000000
secondary = 0xFFFFFFFF
sectype = 0x00000000
image0 = 0xFE000000
image1 = 0xFF000000
maximage = 0x01000000
immr_base = 0xF0000000
bootflags = 0x00000001
intfreq = 133 MHz
busfreq = 66.500 MHz
ethaddr = 00:21:28:16:82:ED
IP addr = 0.0.0.0
baudrate = 9600 bps
## Transferring control to Linux (at address 00000000) ...
## parameters(007ffe90,00000000,00000000,007fff00,007fff80)
Linux version 2.4.22 (kbellew@sanpen-rh5-1) (gcc version 3.3.4) #2 Tue Jul 29 13:14:31 PDT 2008 r35415
On node 0 totalpages: 16384
zone(0): 16384 pages.
zone(1): 0 pages.
zone(2): 0 pages.
Kernel command line: root=/dev/mtdblock4 rootfstype=squashfs ro mtdparts=phys:384K(u1),128k(e1),1536K(k1),14M(r1),384K(u2),128K(e2),1536K(k2),14M(r2)
Decrementer Frequency = 498750000/60
m8xx_wdt: active wdt found (SWTC: 0xFFFF, SWP: 0x1)
m8xx_wdt: keep-alive trigger installed (PITC: 0x1000)
Calibrating delay loop... 132.71 BogoMIPS
Memory: 62828k available (1416k kernel code, 444k data, 68k init, 0k highmem)
Dentry cache hash table entries: 8192 (order: 4, 65536 bytes)
Inode cache hash table entries: 4096 (order: 3, 32768 bytes)
Mount cache hash table entries: 512 (order: 0, 4096 bytes)
Buffer cache hash table entries: 4096 (order: 2, 16384 bytes)
Page-cache hash table entries: 16384 (order: 4, 65536 bytes)
POSIX conformance testing by UNIFIX
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
Starting kswapd
Journalled Block Device driver loaded
JFFS2 version 2.1. (C) 2001 Red Hat, Inc., designed by Axis Communications AB.
squashfs: version 3.0 (2006/03/15) Phillip Lougher
CPM UART driver version 0.03
ttyS00 at 0x0100 is apty: 256 Unix98 ptys configured
Generic RTC Driver v1.07
eth0: FEC ENET Version 0.2, FEC irq 3, MII irq 6, addr 00:21:28:16:82:ed
RAMDISK driver initialized: 16 RAM disks of 18432K size 1024 blocksize
eth0: Phy @ 0x0, type DM9161 (0x0181b881)
loop: loaded (max 8 devices)
physmap flash device: 2000000 at fe000000
Amd/Fujitsu Extended Query Table v1.3 at 0x0040
number of CFI chips: 1
Using command line partition definition
Creating 8 MTD partitions on "Physically mapped flash":
mtdblock1: 0x00000000-0x00060000 : "u1"
mtdblock2: 0x00060000-0x00080000 : "e1"
mtdblock3: 0x00080000-0x00200000 : "k1"
mtdblock4: 0x00200000-0x01000000 : "r1"
mtdblock5: 0x01000000-0x01060000 : "u2"
mtdblock6: 0x01060000-0x01080000 : "e2"
mtdblock7: 0x01080000-0x01200000 : "k2"
mtdblock8: 0x01200000-0x02000000 : "r2"
i2c-core.o: i2c core module version 2.6.1 (20010830)
i2c-dev.o: i2c /dev entries driver module version 2.6.1 (20010830)
i2c-rpx.o: i2c MPC8xx module version 2.6.1 (20010830)
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 512 buckets, 4Kbytes
TCP: Hash tables configured (established 4096 bind 8192)
ip_conntrack version 2.1 (512 buckets, 4096 max) - 292 bytes per conntrack
ip_tables: (C) 2000-2002 Netfilter core team
ipt_recent v0.3.1: Stephen Frost <sfrost@snowman.net>.http://snowman.net/projects/ipt_recent/
arp_tables: (C) 2002 David S. Miller
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
VFS: Mounted root (squashfs filesystem) readonly.
Freeing unused kernel memory: 68k init
SQUASHFS error: zlib_fs returned unexpected result 0xfffffffd
SQUASHFS error: Unable to read fragment cache block
SQUASHFS error: Unable to read page, block 5bc1e7, size 717d
modprobe: modprobe: Can't open dependencies file /lib/modules/2.4.22/modules.dep (No such file or directory)
modprobe: modprobe: Can't open dependencies file /lib/modules/2.4.22/modules.dep (No such file or directory)
Kernel panic: No init found.Try passing init= option to kernel.
<0>Rebooting in 180 seconds..
设备型号：Sun SPARC Enterprise T5220
问题描述：
内存扩容，原有配置是Install 1st都安装，给Install 2st都扩容了一根，与之前安装的条子大小、频率等参数都匹配，且是SUN的。但是安装之后服务器无法启动，串口输出内容如上。感觉好像是ILOM挂了，大侠们谁有好的处理办法啊？除了换板子之外。谢谢！ 自己顶一下！ 给内存扩容的时候，注意应该是DIMM扩的，不能只扩一条吧 是一组的 我有点晕了.
T5520 上装的是 Linux ? 还是 PowerPC版的 ?
高级货, 没玩过 . ... ... 回复 5# q1208c
T5220只能装solaris 你看到的linux是ilom 回复 6# KYOKOF
:em02:多谢指点.
页:
[1]