LSI Corporation SAS2 IR Configuration Utility.
Version 6.250.02.00 (2010.06.30)
Copyright (c) 2009-2010 LSI Corporation. All rights reserved.
SAS2IRCU: No command specified.
sas2ircu <controller #> <command> <parameters> ...
where <controller #> is:
Number between 0 and 255
where <command> is:
DISPLAY - display controller, volume and physical device info
LIST - Lists all available LSI adapters (does not need ctlr #>
CREATE - create an IR volume
DELETE - Delete entire RAID configuration on the selected controller
DELETEVOLUME- Delete a specific RAID Volume on the selected controller
HOTSPARE - make drive a hot spare
STATUS - display current volume status info
CONSTCHK - Start Consistency Check operation on the specified IR Volume
ACTIVATE - Activate an Inactive IR volume
LOCATE - Locate a disk drive on an enclosure
LOGIR - Upload or Clear IR Log data
BOOTIR - Select an IR Boot Volume as primary boot device
BOOTENCL - Select an Enclosure/Bay as primary boot device
where <parameters> are:
Command specific values; enter "sas2ircu <controller #> <command>"
to get command specific help 蜘蛛哥啊，有没有文档案例什么的，现在遇到这种情况了，可能过几天就要去搞，嗨没弄过心里没底。回复 11# 东方蜘蛛
kwtip 发表于 2014-04-24 22:47 static/image/common/back.gif
蜘蛛哥啊，有没有文档案例什么的，现在遇到这种情况了，可能过几天就要去搞，嗨没弄过心里没底。回复 11# 东 ...
通用的做法，先得看是什么Raid hba, 然后收集相应的信息。
SGX-SAS6-R-INT-Z
(MegaCLI)
SGX-SAS6-INT-Z
sas2ircu
通用的日志/var/log/messages* 看看你的背板是不是有问题？ 然后devfsadm
页:
1
[2]