njttian 发表于 2014-04-21 19:59

[已解决]HP-UX系统输入boot命令报错！

本帖最后由 lbseraph 于 2014-05-09 11:04 编辑

一台HP 2000的机器，装的HP-UX 10.2的系统，开机无法进入系统。输入boot命令选择进入硬盘，有报错信息，如图：。后面又尝试了下，“boot”命令后面跟不同的参数， 还是提示同样的错误 ！

解决方法：主板电池接反了，纠正即可。

tangye 发表于 2014-04-21 23:51

P2是磁带机？

lgatuk 发表于 2014-04-22 08:48

对 p2是磁带机 你应该boot p0   这个才是硬盘
另外@lbseraph师傅 p1是啥

tangye 发表于 2014-04-22 09:44

lgatuk 发表于 2014-04-22 08:48 static/image/common/back.gif
对 p2是磁带机 你应该boot p0   这个才是硬盘
另外@lbseraph师傅 p1是啥

P1是本地硬盘啊。应该是换了块Compaq的9GB硬盘

njttian 发表于 2014-04-22 10:40

bootP0P1P2都试过，报一样的错！

lgatuk 发表于 2014-04-22 11:54

本帖最后由 lgatuk 于 2014-04-22 11:57 编辑

The easiest thing for you to try would be to replace the button battery to see if that has an effect. If not then it is your system board that is at fault.


Usually this problem is caused by a hardware misconfiguration. If
you have added any hardware or made any changes to your system,
check your configuration settings and ensure that everything is
configured correctly. Refer to the documentation that was provided
with your new hardware for any assistance.

lbseraph 发表于 2014-04-23 17:10

回复 1# njttian

参考链接：
http://h30499.www3.hp.com/t5/Workstations-Itanium-Based/Stop-boot-flag-set-system-cannot-boot-RTC-problem/td-p/3502340#.U1eDFfmSxr0
http://h30499.www3.hp.com/t5/System-Administration/stop-boot-flag/td-p/2533883#.U1eDFfmSxr0

njttian 发表于 2014-05-09 09:40

找到原因了。主板上面的电池上反了！
页: [1]
查看完整版本: [已解决]HP-UX系统输入boot命令报错！