Impact: Function Severity: Special Attention
New function:
On i5 systems, added support for booting from a boot device attached to an IOP-less adapter.
Added support for the installation of two copies of the AIX operating system on one hard file. This includes support in the SMS menus for booting from either one.
Added support for feature code 1812, the GX Dual-port 4x InfiniBand Host Channel Adapter, on model 52A systems.
Added support for feature code 1811, the GX Dual-port 4x InfiniBand Host Channel Adapter, on model 575 systems.
Added support for moving the CUoD resources from one system to another system.
Added support for the capability to set up a backup shared ethernet so that the shared ethernet function can fail-over to a standby shared ethernet if the primary fails. This function is part of the virtual IO server.
Added support for redundant service processors with dynamic failover in models 570, 590, and 595.
Added support for modifying the number of On/Off CoD activations during the active period.
Added support for unattended HMC installation over a network, and to back up full HMC disk images onto a network server.
Added support for new models: 9131-52A, 9111-28 , 9133-55A, 9110-51A, 9115-505.
Various enhancements to the ASCII version of the Advanced System Management Interface (ASMI) menus were made.
Problems resolved:
Fixed a problem that was causing the user data in a service processor error log entry generated by the bulk power controller to be truncated to 2048 bytes.
Fixes a problem that caused unnecessary Service Agent calls because SRC B1816009 was being generated when the white power button was pressed before the power-on sequence was complete.
On model 590 and 595 systems, fixed a problem that was causing DDR II memory cards in slots C10 and C12 to fail the memory test during a slow-mode boot.
Fixed a problem that was causing a platform dump to be incomplete under certain circumstances.
Fixed a problem that was causing a hypervisor dump to be corrupted.
Fixed a problem that caused the location codes to be incorrect after the planar is replaced in a pSeries 7311-D20 drawer.
The timestamp from the bulk power controller was added into the serviceable event log entry.
Fixed a problem that prevented the "nvunalias" open firmware command from working.
Fixed a problem that kept the physical I/O description field on the HMC GUI from being updated after a "remove FRU and add FRU" operation.
Fixed a problem that caused a service processor dump or a platform dump and SRC B1817201 or B7004400.
Changed the firmware so that a modem attached to a system port will reconfigure to enable call-in following a power failure.
Fixed VPD-related command hangs (such as lsmcode, lsvpd, snap)
Fixed several problems associated with firmware installations:
SRC B1814008 or B181F131 was generated on reboot
A service processor dump occurred during a firmware installation
"lsmcode -c" command displayed all zeros for the firmware level on the T side after an installation作者: edna 时间: 2011-09-02 12:02 回复 9#qingzhou
用DM 安装微码，三种方式的CONSOLE都好用的啊。