12. Use the SCCLI to verify the current controller firmware using the firmware
application menu. Choose "show inquiry-data". If the
firmware version reported is 3.27Q or later, this patch will work.
13. Make certain to quiesce the FC bus to the minnow.
14. Open a terminal window on the host that will be used to download the
firmware. Change your working directory, if necessary, to the
directory in which the patch was unpacked and confirm that the
ST330000F.055A.fw file is present using the "ls" command.
15. Type "./var/sadm/swimages/119000-02/mload <STOREdge3510 IP Address>" at the command prompt.
mload responds with "Please Enter Hostname or IP Address Of 3xxx platform for upgrade:"
Re-enter the IP <STOREdge3510 IP Address> of your STOREdge3510.
16. Download new firmware to all disks at the same time by typing
the following command at the prompt:
You will receive the following warning. Answer it as below:
WARNING: This is a potentially dangerous operation.
The controller will go offline for several minutes.
Data loss may occur if the controller is currently in use.
Are you sure? y
and then wait 4-5 minutes until the prompt appears again.
17. Verify that the latest disk firmware is downloaded by choosing the
"show disks" command to view the DISK drive's firmware revision.