Chinaunix

标题: BT的说明书 [打印本页]

作者: weiscott 时间: 2009-06-04 14:18
标题: BT的说明书

今天领导说要给一台PC机装linux
系统，是技嘉的主板，集成网卡（RTL8168）
我看到的网卡信息是从主板自带的说明书知道的，然后我去下载相关的网卡驱动程序，
找了N个驱动程序，没一个装成功的。
这时没招了，lspci一下，
02:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8101E PCI Express Fast Ethernet controller (rev 02)
结果看到的网卡信息和说明书的大大不一样，汗。
这时下载对应该的驱动程序，顺利安装成功
附readme说明

This is the Linux device driver released for RealTek RTL8101E, RTL8102E(L) and
RTL8103E(L), the Fast Ethernet controller with PCI-Express
interface.
Check
whether the built-in driver, r8169.ko (or r8169.o for kernel 2.4.x), is
installed.
      # lsmod | grep r8169
If it is installed,
please remove it.
      # rmmod r8169
note: If the built-in driver
cannot removed by rmmod, please edit /etc/modprobe.conf and comment 'alias eth0
r8169'. Then, remmove it again or reboot your computer.
Unpack the
tarball :
      # tar vjxf r8101-1.aaa.bb.tar.bz2
Change to the
directory:
      # cd r8101-1.aaa.bb
If you are running the
target kernel, then you should be able to do :
      # make clean
modules (as root or with sudo)
      # make install
      # depmod
-a
      # modprobe r8101
You can check whether the driver is
loaded by using following commands.
      # lsmod | grep r8101

# ifconfig -a

本文来自ChinaUnix博客，如果查看原文请点：http://blog.chinaunix.net/u3/98137/showart_1954999.html

欢迎光临 Chinaunix (http://bbs.chinaunix.net/)