#
# Redraw interval (in ms)
# must be between 1 and 999
#
# If you set this higher, PearPC will spend less time doing redraws (and so run faster)
# but feel less responsive. You should adjust this to your computer speed and personal
# preference.
#
redraw_interval_msec = 200
#
# Loader
#
#
# Boot method
# this can be
# 1. "auto", prom will boot the first bootable partition found (default)
# 2. "select", prom will show you a list of bootable partitions
# 3. "force", prom will load and boot the local file prom_loadfile
#
prom_bootmethod = "auto"
# Example of how to use "force":
#prom_bootmethod = "force"
#prom_loadfile = "test/yaboot"
#prom_env_bootpath = "disk"
#
# bootargs: don't change unless you know what you are doing
# machargs: set to "-v" to get a verbose startup
#
#prom_env_bootargs = ""
prom_env_machargs = "-v"
#
# This is needed if you want to boot Mac OS X
#
prom_driver_graphic = "video.x"
# This will adjust the position of the initial page table (don't change)
#page_table_pa = 104857600
#
# CPU Config
#
# Processor Version Register
# Defaults to 0x00088302
# Only change if you know want you are doing
#
#cpu_pvr = 0x00088302
#
# Main memory (default 128 MiB)
# must be >;= 64 MiB
#
#memory_size=0x10000000
#
# IO Devices
#
#
# PCI IDE Config
#
# Drive type will be set according to file extension:
# .img: Harddisk (filesize must be multiple of 516096)
# .iso: CD-Rom
# Or you can override this by specifying the type via
# pci_ide0_master_type / pci_ide0_slave_type
