标题: 求助：ultra10的asy1:silo overflow 问题 [打印本页] 作者: njdexp 时间: 2006-06-11 08:09 标题: 求助：ultra10的asy1:silo overflow 问题 ultra10的机器，启动进入CDE后，过几分钟跳出来，出现：\r\nNOTICE：asy1:silo overflow \r\nNOTICE：asy0:silo overflow \r\nNOTICE：asy1:ring buffer overflow \r\n的错误信息，然后进入到OK状态。\r\n想请教一下，是不是主板有问题了？\r\n谢谢回答！作者: bloomit 时间: 2006-06-11 09:40
A \"silo overflow\" happens when input to a serial line comes in faster than the computer can process it. \r\n\r\n\r\nThe \"silo\" referred to is a hardware input buffer associated with a serial port. The serial line hardware (e.g., ALM board) detects when the buffer overflows and sets a bit in a status register to warn the computer that some incoming data was lost on a given line. \r\n\r\nasy0 is a Asynchronous Serial Ports serial device \r\nName asy0 \r\nModel Description Asynchronous Serial Ports \r\nType serial device \r\nUnit 0 \r\nNode ID -526576960 \r\n \r\nasy1 is a Asynchronous Serial Ports serial device \r\nName asy1 \r\nModel Description Asynchronous Serial Ports \r\nType serial device \r\nUnit 1 \r\nNode ID -526577152作者: njdexp 时间: 2006-06-11 10:19
那就是主板上有部件有问题？