Chinaunix

标题: emc2 clariion fc4400盘阵有没有人搞过？ [打印本页]

作者: 5i6000 时间: 2004-09-13 12:32
标题: emc2 clariion fc4400盘阵有没有人搞过？
想知道怎么用console联上去设置？

作者: lgl 时间: 2004-09-13 20:04
标题: emc2 clariion fc4400盘阵有没有人搞过？
用超级终端就是了，参数为默认。
那里有fc4400这个型号！？

作者: 5i6000 时间: 2004-09-14 01:37
标题: emc2 clariion fc4400盘阵有没有人搞过？

原帖由 "lgl" 发表：
用超级终端就是了，参数为默认。
那里有fc4400这个型号！？

搞错，是4500

好像不光是超级终端的问题。好像要用软件cli的。光超级终端启动了以后出一些信息以后就没有信息了。

etting the storage-system properties to the values required for PowerPath works consistently through serially connected PC. This computer requires:

? Windows NT 4.0 with Service Pack 5 or Windows 2000.

? EMC ControlCenter Navisphere 6.1 or higher Windows Host Agent and CLI.

To set up a serial connection to the storage system:

a. Connect a serial/null modem cable between the computer’s COM 1 port and the console (serial) port on SP A.

b. On the computer, verify that you are logged in as a privileged user.

c. Using a text editor, open the Host Agent configuration file:

Program Files\EMC\Navisphere Agent\agent.config

d. Edit the file by commenting out the entry device auto auto by adding a # before the first letter in the entry and adding the following entries:

poll 240
ttydevice com1 com1 “com1”
baud 9600
eventlog 1

e. Save the file.

f. Stop and start the Host Agent.

IMPORTANT Depending on the size and arrangement of your configuration, it may take several minutes for the Host Agent to complete startup.

g. Verify that the Agent has completed startup and is running over a valid serial connection by typing cd into the cli directory

C:cd program files\emc\navisphere cli

Type navicli -np getagent

Repeat the above getagent command until the display shows the new connection.

Once the Agent is running, you can use it to configure the FC4500/5300 for PowerPath as described below.

Use Navisphere CLI to set the appropriate default storage-system properties to the values for PowerPath:

navicli –np –d com1 type 3

navicli –np –d com1 failovermode 1

navicli –np –d com1 arraycommpath 1

navicli –np –d com1 unitserialnumber lun

Disconnect the PC from the serial port on the storage system.

另不接那个电池是不是cache就不能enable??

欢迎光临 Chinaunix (http://bbs.chinaunix.net/)