标题: 请教高手关于picld不正常的原因, 谢谢! [打印本页] 作者: mcs 时间: 2005-02-19 19:14 标题: 请教高手关于picld不正常的原因, 谢谢! V440报一电源不正常, 检查发现最左边亮菊黄灯, 但中间和右边都是绿色, 同时发现命令prtdiag工作不正常, 报"picl_initialize failed
Daemon not responding
Cannot display environmental status" 用ps -ef|grep picld发现picld已停止工作, 用/etc/init.d/picld start启动, prtdiag恢复正常, 发现电源的错误是
Supply Status Fan Fail Temp Fail CS Fail 3.3V 5V 12V 48V
------ ------------ -------- --------- ------- ---- -- --- ---
PS0 GOOD 8 4 3 6
PS1 FAIL ON OFF OFF 7 4 3 6
PS2 GOOD 8 4 3 6
但过没多久发现picld又不工作了(用ps -ef|grep picld发现picld不存在), 重新启动, 过几十秒又不工作了, 且prtdiag也无法工作. 换了新的电源, picld倒是还在, 但用prtdiag报如下错
========================= Environmental Status =========================
failed in fill_device_array_from_id for PSVC_KEYSWITCH
Property not found
failed in fill_device_array_from_id for FSP_LED
Property not found
failed in fill_device_array_from_id for DISK
Property not found
failed in fill_device_array_from_id for FAN
Property not found
Power Supplies:
---------------
Supply Status Fan Fail Temp Fail CS Fail 3.3V 5V 12V 48V
------ ------------ -------- --------- ------- ---- -- --- ---
failed in fill_device_array_from_id for PS
Property not found