标题: 在cvsup下make install 时Failed to configure m3cc，怎么办 [打印本页] 作者: babywolfh 时间: 2006-04-26 13:39 标题: 在cvsup下make install 时Failed to configure m3cc，怎么办 在/usr/ports/net/cvsup下使用make install出现以下问题，该怎么办啊：（
环境：vm5.0＋freebsd6.0
===> Extracting for ezm3-1.1
>> Checksum OK for ezm3/ezm3-1.1-FreeBSD4-boot.tar.bz2.
>> Checksum OK for ezm3/ezm3-1.1-src.tar.bz2.
===> Patching for ezm3-1.1
[.....]
---------- building m3cc in language/modula3/m3compiler ----------
/usr/ports/lang/ezm3/work/ezm3-1.1/src/../boot-FreeBSD4/m3build/FreeBSD4/m3build -T /usr/ports/lang/ezm3/work/ezm3-1.1/src/../m3config/src -F /usr/ports/lang/ezm3/work/ezm3-1.1/src/../FreeBSD4/config.tmpl
Created "Makefile" in /usr/ports/lang/ezm3/work/ezm3-1.1/language/modula3/m3compiler/m3cc/FreeBSD4
Configuring libiberty...
creating cache ../config.cache
checking whether to enable maintainer-specific portions of Makefiles... no
checking for makeinfo... makeinfo
[.....]
checking for thread.h... no
checking for pthread.h... yes
checking for CHAR_BIT... yes
checking byte ordering... od: conftest.o: Bad file descriptor
unknown
configure: error: *** unable to determine endianness
Configure in /usr/ports/lang/ezm3/work/ezm3-1.1/language/modula3/m3compiler/m3cc/FreeBSD4/gcc failed, exiting.
mkdir FreeBSD4
--- building in FreeBSD4 ---