标题: Scalar i500 问答求助，急，谢谢 [打印本页] 作者: rgbtflss 时间: 2006-12-13 16:46 标题: Scalar i500 问答求助，急，谢谢 1. What is the purpose of the /kernel/drv/st.conf Solaris configuration file?
A Define HBA persistent bindings
B Define Disk Device behavior and Target instances
C Configure SCSI to FC_LUN mappings
D Define Tape device behavior and Target instances
2. Which file(s) must be edited to correctly configure persistent bindings to Targets attached to a Emulex FC HBA installed in a Solaris Server?
A /kernel/drv/st.conf
B /kernel/drv/lpfc.conf
C /kernel/drv/jnic.conf
D /etc/devlink.tab
3. After installing a software package using the "pkgadd" on a Sun server in a production environment, what is the best method to safely reboot the system?
A reboot -- -r
B Power cycle the server power switch
C Sync:Sync:Shutdown –i0 –y , then boot –r from PROM
D reboot
4. Which of the following shows the expected output in the /var/adm/messages file indicating a correct Solaris configuration of the /kernel/drv/st.conf file using Quantum DLT8000 tape drives?
A
B
C
D Module added successfully, but did not attach
5. Which of the following would be recommended by Quantum for use with IBM_LTO Tape drives in Solaris environments?
A Use the native st tape driver and st.conf for all IBM LTO installations
B Use the IBMTape driver and IBMtape.conf for all IBM LTO installations
C Use the native st tape driver and IBM.conf for all IBM LTO installations
D Use the tape driver and .conf file recommended by the Backup Application Vendor
6. Which of the following statements are true for distinguishing Fibre Channel World Wide Node Name (WWNN) and World Wide Port Name (WWPN)?
A WWPN is a 64bit unique identifier for a Fibre Channel Node
B S_ID and D_ID information is encapsulated in the WWNN and WWPN for Fabric transmission
C WWNN is a 64bit unique identifier for a Fibre Channel Port
D Fibre Channel WWNN’s are hard set by Manufacturers and cannot be changed
E None of the above
7. Which statement most accurately describes the “Channel Zoning” feature of an SNC?
A Allows users to assign specific LUN’s to specific Fibre Ports
B Allows users to assign specific SCSI Targets to specific Fibre Ports
C Allows users to assign specific SCSI buses to specific Fibre Ports
D SNC does not support Channel Zoning without VPS作者: rgbtflss 时间: 2006-12-13 16:47 标题: 那位大哥能给个答案呀，谢谢 那位大哥能给个答案呀，谢谢作者: rgbtflss 时间: 2006-12-13 17:05 标题: 为什么没有人能帮帮我 为什么没有人能帮帮我作者: david5337 时间: 2006-12-13 17:20
晕晕，白学了么？？？？作者: rgbtflss 时间: 2006-12-14 09:47 标题: 小弟学的不好，还请大家多多关照给个答案。 小弟学的不好，还请大家多多关照给个答案。