- 论坛徽章:
- 0
|
H85 shutdown -F 后死机,怎讲?
Flashing 888 in Operator Panel Display
Purpose of This MAP
A flashing 888 number suggests that either a hardware or software problem has been detected and a diagnostic message is ready to be read.
A Type 102 message is generated when a software or hardware error occurs during system execution of an application. Use the following steps and information to determine the content of the type 102 message. Crash and dump status codes are listed later in this section.
102 = Message type RRR = Crash code (the three-digit code that immediately follows the 102) SSS = Dump status code (the three-digit code that immediately follows the Crash code)
Crash Codes
Note: Some systems may produce 4-digit codes. If the leftmost digit of a 4-digit
code is 0, use the three rightmost digits.
The following crash codes are part of a Type 102 message.
207 Machine check because of an unidentified error.
Dump Progress Indicators (Dump Status Codes)
The following dump progress indicators, or dump status codes, are part of a Type
102 message.
Note: When a lowercase c is listed, it displays in the lower half of the character position. Some systems produce 4-digit codes, the two leftmost positions can have a blanks or zeros. Use the two rightmost digits.
0c0 The dump completed successfully. |
|