- 论坛徽章:
- 0
|
本帖最后由 ulovko 于 2012-10-28 16:14 编辑
大家好,第一次使用PF限制单ip网速,但是没有起到相应的作用
现在是把总网速限制在了1.5Mb(pc1_net+pc2_net总共1.5Mb),而我想要达到的效果是每个ip限制到1.5Mb(pc1_net,pc2_net分别1.5Mb),请问我哪里写错了,怎样更正,在这里先谢谢了
# $OpenBSD: pf.conf,v 1.50 2011/04/28 00:19:42 mikeb Exp $
#
# See pf.conf(5) for syntax and examples.
# Remember to set net.inet.ip.forwarding=1 and/or net.inet6.ip6.forwarding=1
# in /etc/sysctl.conf if packets are to be forwarded between interfaces.
set skip on lo
# filter rules and anchor for ftp-proxy(8)
#anchor "ftp-proxy/*"
#pass in quick inet proto tcp to port ftp divert-to 127.0.0.1 port 8021
# anchor for relayd(8)
#anchor "relayd/*"
pass # to establish keep-state
# rules for spamd(8)
#table <spamd-white> persist
#table <nospamd> persist file "/etc/mail/nospamd"
#pass in on egress proto tcp from any to any port smtp \
# rdr-to 127.0.0.1 port spamd
#pass in on egress proto tcp from <nospamd> to any port smtp
#pass in log on egress proto tcp from <spamd-white> to any port smtp
#pass out log on egress proto tcp to any port smtp
#block in quick from urpf-failed to any # use with care
# By default, do not permit remote connections to X11
block in on ! lo0 proto tcp to port 6000:6010
altq on tun0 priq bandwidth 640Kb queue { std_out, tcp_ack_out }
queue std_out priq(default)
queue tcp_ack_out priority 6
altq on msk0 cbq bandwidth 6Mb queue { std_in }
queue std_in bandwidth 1.5Mb cbq(default)
ext_if="tun0"
int_if="msk0"
local_net = "192.168.0.0/24"
pc1_net = "192.168.0.19"
pc2_net="192.168.0.21"
pass out on $ext_if inet proto {tcp,udp} from $int_if:network to $ext_if flags S/SA keep state(source-track rule, max-src-nodes 50,max-src-states 100)
pass out on $ext_if from $int_if:network to any nat-to ($ext_if) queue(std_out,tcp_ack_out)
pass out on $ext_if from any to $pc1_net keep state queue std_in
pass out on $ext_if from any to $pc2_net keep state queue std_in |
|