FC3510 Controller BBU is charging。急！！！！

sheep1230

超级终端提示，Controller BBU is charging！
这种情况是不是无法更改3510配置的？
大概要充电多久能充好啊？
而且我在终端里看到BAT已经是+++++了，应该是充好电了，怎么会还在充电呢？
谢谢各位大侠啦，帮帮忙啊!!!

[ 本帖最后由 sheep1230 于 2009-3-29 21:28 编辑 ]

easybegin

Bug 4825806: BBU warnings should not be as severe. The Sun StorEdge 3510 FC array has a battery circuit board that monitors and charges the battery during normal operation. Since the battery is not charging while the array is powered off, some of the charge of the battery will dissipate. When the array is powered on, the battery circuit board will detect the power dissipation of the battery and will display the following message: "|[0125] WARNING: Controller BBU Not Fully Charged" and begin to recharge the battery. Once the battery is fully charged, the following message will be displayed: "|[01A5] NOTICE: Controller BBU Fully Charged!"

minechina

没弄过，帮你顶起来。

doging

没事的，多按几次esc就没了