- 论坛徽章:
- 1
|
抓的信息,换硬盘是不是直接插上就好了呢？
db2:/dev# sautil /dev/ciss4
******************************************************************************
**** ****
**** S A U T I L S u p p o r t U t i l i t y ****
**** ****
**** for the HP SmartArray RAID Controller Family ****
**** ****
**** version A.02.09 ****
**** ****
**** (C) Copyright 2003-2005 Hewlett-Packard Development Company, L.P. ****
******************************************************************************
---- DRIVER INFORMATION ------------------------------------------------------
Driver State........................ READY
---- CONTROLLER INFORMATION --------------------------------------------------
Controller Product Number........... A9890A
Controller Product Name............. HP PCI-X SmartArray 6402
Hardware Path....................... 0/2/1/0/4/0
Serial Number....................... P57820RXQSE0NM
Device File......................... /dev/ciss4
Hardware Revision................... 'B'
Boot Block Revision................. 3.86
Firmware Revision (running)......... 2.34
Firmware Revision (in ROM).......... 2.34
Firmware Revision (inactive)........ 2.34
# of Logical Drives................. 1
# of Physical Disks Configured...... 2
# of Physical Disks Detected........ 1
Logical Drive Rebuild Priority...... 0 (low)
Array Capacity Expansion Priority... 0 (low)
Auto-Fail Missing Disks at Boot..... disabled
SCSI Transfer Detection Mode........ Auto Detect
---- ARRAY ACCELERATOR (CACHE) INFORMATION -----------------------------------
Array Accelerator Board Present?.... yes
Cache Configuration Status.......... cache enabled
Cache Ratio......................... 50% Read / 50% Write
Total Cache Size (MB)............... 128
Read Cache........................ 064
Write Cache....................... 064
Transfer Buffer................... 000
Battery Pack Count.................. 2
Battery Status (pack #1)............ ok
Battery Status (pack #2)............ ok
---- LOGICAL DRIVE SUMMARY ---------------------------------------------------
# RAID Size Status
0 1+0 70001 MB USING INTERIM RECOVERY MODE
---- SCSI DEVICE SUMMARY -----------------------------------------------------
Location Ch ID Type Capacity Status
N/A 1 1 N/A N/A FAILED
internal 2 0 DISK 73.4 GB OK
---- SCSI BUS SUMMARY --------------------------------------------------------
External Internal
Ch LVD_Mode Connector Connector
1 YES - YES
2 YES - YES
---- LOGICAL DRIVE 0 ---------------------------------------------------------
Logical Drive Device File........... c4t0d0
Fault Tolerance Mode................ RAID 1+0 (Disk Mirroring)
Logical Drive Size.................. 70001 MB
Logical Drive Status................ USING INTERIM RECOVERY MODE
# of Participating Physical Disks... 2
Participating Physical Disk(s)...... Ch:ID
1: 1 <-- NOT RESPONDING
2: 0
Participating Spare Disk(s)......... Ch:ID
none
Stripe Size......................... 128 KB
Logical Drive Cache Status.......... cache enabled
Configuration Signature............. 0xA01473A2
Media Exchange Detected?............ no
---- SCSI DEVICE 2:0 [DISK] --------------------------------------------------
Connector Location............................... internal
Channel Number................................... 2
SCSI ID.......................................... 0
Device Type...................................... DISK
Disk Capacity.................................... 73.4 GB
Device Status.................................... OK
Device Vendor ID................................. HP 73.4G
Device Product ID................................ MAX3073NC
Device Serial Number............................. X1002701 0542
Device Firmware Version.......................... HPC1
SCSI Transfer Rate (actual)...................... Ultra-320
Reserved Area (cfg/status info).................. 557.1 KB (0.6 MB)
Block Size (bytes/sector)........................ 512 bytes
M&P Data Stamped?................................ no
Last Failure Reason.............................. none
Physical Disk Flags:
Disk present and operational................... yes
Non-disk device detected....................... no
Wide SCSI transfer enabled..................... yes
Synchronous (Fast/Ultra) transfer enabled...... yes
Narrow disk tray detected...................... no
Wide transfer failed, reverted to narrow....... no
Ultra SCSI transfer enabled.................... yes
Ultra-2 SCSI transfer enabled.................. yes
S.M.A.R.T. supported........................... yes
S.M.A.R.T. errors (in factory M&P data)........ no
S.M.A.R.T. enabled............................. yes
S.M.A.R.T. errors (in powerup M&P data)........ no
Attached to external channel................... no
Configured in a logical drive.................. yes
Configured as a spare disk..................... no
Disk write cache enabled at spin up............ no
Running in DT clocking mode.................... yes
Supports DT clocking mode only................. no
Supports DT and ST clocking modes.............. yes
Running in U320 mode........................... yes
Packetized SCSI supported...................... yes
Supports redundant controller operation........ yes
Disk write cache enabled in current page....... no
Disk write cache disabled in default page...... no
QAS capable (U320 only)........................ yes
Currently running QAS (U320 only).............. yes
---- DIAGRAM OF EXTERNAL CONNECTORS ON BRACKET -------------------------------
========---========
| |
| U320 <--- LOOK FOR THIS LOGO
| / \ |
| <- |
| \ / |
| |
| * * |
| * * * * |
(Ch A1)---> * * * * <--- (Ch A2)
| * * * * |
| * * |
| |
| |
| |
| |
| |
| |
| |
| |
| |
~ ~ ~ ~ ~
******************************************************************************
**** End of SAUTIL Output ****
******************************************************************************
db2:/dev# |
|
免费注册
发表于 2009-09-04 14:58
