用了format flash:命令,救命!

十四狼

拿了一台cisco2950的设备来玩 用了format flash:命令 重启后就只有switch:命令行了 \r\n\r\n怎么能恢复到设备的初始状态啊 麻烦步骤详细一点 我是菜鸟.\r\n\r\n救命啊!!!

v_cat

Step 1   Connect a PC with terminal-emulation software supporting the XMODEM Protocol to the switch console port.\r\n\r\nStep 2   Set the line speed on the emulation software to 9600 baud.\r\n\r\nStep 3   Disconnect the switch power cord.\r\n\r\nStep 4   Reconnect the power cord to the switch.\r\n\r\nThe software image does not load. The switch starts in boot loader mode, which is indicated by the switch# prompt.\r\n\r\nStep 5   Use the boot loader to enter commands, and start the transfer.\r\n\r\nswitch# copy xmodem: flash:image_filename.bin\r\n用XMODEM把文件再传上去

jacal

XMODEM很痛苦的，不过只有这种办法了，你就慢慢传吧