- 论坛徽章:
- 0
|
系统启动时报错:
************* SYSTEM ALERT **************
SYSTEM NAME: uninitialized
ALERT LEVEL: 8 = Boot Possible, performance impaired
REASON FOR ALERT
SOURCE: 6 = platform
SOURCE DETAIL: 6 = service processor SOURCE ID: 0
PROBLEM DETAIL: 1 = selftest result
LEDs: RUN ATTENTION FAULT REMOTE POWER
FLASH FLASH ON OFF ON
LED State: Boot Failed. Running non-OS code. Non-critical error detected.
Check Chassis and Console Logs for error messages.
0x7010028166002030 0B0003FF DD0C0045 - type 14 = Problem Detail
0x4810028166002030 67720000 7361734D - type 9 = ASCII Message sasMgr
0x4810028166002030 78632E43 4C4F4765 - type 9 = ASCII Message LOGexc.C
0x7010028166002030 00000000 00002F35 - type 14 = Problem Detail
0x70100A8166002030 0003292E 2F2A2000 - type 14 = Problem Detail
A: ack read of this entry - X: Disable all future alert messages
Anything else skip redisplay the log entry
->Choice:a
*****************************************
Firmware Version 43.22
********** VIRTUAL FRONT PANEL **********
System Boot detected
*****************************************
LEDs: RUN ATTENTION FAULT REMOTE POWER
FLASH FLASH ON OFF ON
LED State: Boot Failed. Running non-OS code. Non-critical error detected.
Check Chassis and Console Logs for error messages.
platform config 626F
*****************************************
************ EARLY BOOT VFP *************
End of early boot detected
*****************************************
------------------------------------------------------------------------------
(c) Copyright 1995-2002, Hewlett-Packard Company, All rights reserved
------------------------------------------------------------------------------
Processor Speed State CoProcessor State Cache Size
Number State Inst Data
--------- -------- --------------------- ----------------- ------------
0 750 MHz Active Functional 750 KB 1.5 MB
2 750 MHz Idle Functional 750 KB 1.5 MB
Central Bus Speed (in MHz) : 133
Available Memory : 1048576 KB
Good Memory Required : 36592 KB
Primary boot path: 0/0/2/0.0
Alternate boot path: 0/0/2/0.2
Console path: 0/0/4/1.0
Keyboard path: 0/0/4/0.0
Processor is booting from first available device.
To discontinue, press any key within 10 seconds.
Information Menu: Enter command > bo
Interact with IPL (Y, N, or Cancel)?> n
Booting...
Boot IO Dependent Code (IODC) revision 1
************* SYSTEM ALERT **************
SYSTEM NAME: uninitialized
DATE: 02/25/2008 TIME: 01:07:44
ALERT LEVEL: 6 = Boot possible, pending failure - action required
REASON FOR ALERT
SOURCE: 8 = I/O
SOURCE DETAIL: 6 = disk SOURCE ID: 0
PROBLEM DETAIL: 0 = no problem detail
GSP卡错误日志:
Log Entry # 0 :
SYSTEM NAME: uninitialized
ALERT LEVEL: 8 = Boot Possible, performance impaired
SOURCE: 6 = platform
SOURCE DETAIL: 6 = service processor SOURCE ID: 0
PROBLEM DETAIL: 1 = selftest result
CALLER ACTIVITY: 2 = operation STATUS: 0
CALLER SUBACTIVITY: 03 = console
REPORTING ENTITY TYPE: 1 = service processor REPORTING ENTITY ID: 00
0x7010028166002030 0B0003FF DD0C0045 type 14 = Problem Detail
0x4810028166002030 67720000 7361734D type 9 = ASCII Message sasMgr
0x4810028166002030 78632E43 4C4F4765 type 9 = ASCII Message LOGexc.C
0x7010028166002030 00000000 00002F35 type 14 = Problem Detail
0x70100A8166002030 0003292E 2F2A2000 type 14 = Problem Detail
Type CR for next entry, Q CR to quit.
Log Entry # 1 :
SYSTEM NAME: uninitialized
DATE: 02/22/2008 TIME: 09:14:27
ALERT LEVEL: 15 = Fatal hardware or configuration problem prevents operation
SOURCE: 8 = I/O
SOURCE DETAIL: 6 = disk SOURCE ID: 0
PROBLEM DETAIL: 3 = functional failure
CALLER ACTIVITY: 1 = test STATUS: 0
CALLER SUBACTIVITY: 48 = implementation dependent
REPORTING ENTITY TYPE: 0 = system firmware REPORTING ENTITY ID: 00
0x000000F386001480 00000000 00000000 type 0 = Data Field Unused
0x580008F386001480 00006C01 16090E1B type 11 = Timestamp 02/22/2008 09:14:27
用光盘引导:
Main Menu: Enter command or menu > sea
Searching for potential boot device(s)
This may take several minutes.
To discontinue search, press any key (termination may not be immediate).
IODC
Path# Device Path (dec) Device Path (mnem) Device Type Rev
----- ----------------- ------------------ ----------- ----
P0 0/0/2/0.0 intscsia.0 Random access media 1
P1 0/0/2/1.0 Random access media 1
Main Menu: Enter command or menu > bo p1
Interact with IPL (Y, N, or Cancel)?> n
Booting...
Boot IO Dependent Code (IODC) revision 1
HARD Booted.
ISL Revision A.00.43 Apr 12, 2000
ISL booting hpux (;0):INSTALL
Boot
: disk(0/0/2/1.0.0.0.0.0.0;0):WINSTALL
8941568 + 1642496 + 2596176 start 0x1fef68
alloc_pdc_pages: Relocating PDC from 0xffff800000 to 0x3fb01000.
引导到这系统不能往下引导,请教高手帮忙,谢谢! |
|
免费注册
发表于 2008-02-25 09:35
