- 论坛徽章:
- 0
|
我的PIX525 IOS是7.1(2)的，在接口下配置了IP ADDRESS，当用nameif inside命令后再sh inter eth0看就显示如下信息：
pixfirewall# sh inter eth0
Interface Ethernet5 "test", is up, line protocol is up
Hardware is i82559, BW 100 Mbps
Auto-Duplex(Full-duplex), Auto-Speed(100 Mbps)
MAC address 00e0.b604.6a59, MTU 1500
IP address unassigned
100 packets input, 11367 bytes, 0 no buffer
Received 100 broadcasts, 0 runts, 0 giants
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
23 L2 decode drops
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 babbles, 0 late collisions, 0 deferred
0 lost carrier, 0 no carrier
input queue (curr/max blocks): hardware (128/12 software (0/7)
output queue (curr/max blocks): hardware (0/0) software (0/0)
Traffic Statistics for "test":
71 packets input, 7471 bytes
0 packets output, 0 bytes
54 packets dropped
为什么我一用nameif命令接口地址就报IP address unassigned？当我no nameif inside后再看就正常了：
pixfirewall# sh inter eth5
Interface Ethernet5 "", is up, line protocol is up
Hardware is i82559, BW 100 Mbps
Auto-Duplex(Full-duplex), Auto-Speed(100 Mbps)
Available but not configured via nameif
MAC address 00e0.b604.6a59, MTU not set
IP address 172.16.1.1, subnet mask 255.255.255.0
139 packets input, 14394 bytes, 0 no buffer
Received 139 broadcasts, 0 runts, 0 giants
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
28 L2 decode drops
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 babbles, 0 late collisions, 0 deferred
0 lost carrier, 0 no carrier
input queue (curr/max blocks): hardware (128/12 software (0/7)
output queue (curr/max blocks): hardware (0/0) software (0/0)
请问这是怎么回事？谢谢了 |
|
免费注册
发表于 2007-12-26 20:50
