WARNING: could not set smbboot FDT_ERR_NOSPACE.

deep_pro

移植mpc8315时遇到问题，2.6.27编译出的dts无法被freescale官方的uboot1.3.0支持，报错
=> run sataboot
## Booting image at fe500000 ...
   Image Name:   Linux-2.6.27.7
   Created:      2011-02-14   9:18:25 UTC
   Image Type:   PowerPC Linux Kernel Image (gzip compressed)
   Data Size:    1758532 Bytes =  1.7 MB
   Load Address: 00000000
   Entry Point:  00000000
   Verifying Checksum ... OK
   Uncompressing Kernel Image ... OK
   Booting using the fdt at 0xfe700000
   Loading Device Tree to 007fe000, end 007ffa0b ... OK
WARNING: could not set smbboot FDT_ERR_NOSPACE.
ERROR: /u-boot-env node create failed - must RESET the board to recover.
Resetting the board.

查到资料If DTS_FLAGS parameter omitted than following error will occur, because there is not enough space in the file, where the u-Boot can store some additional data about buses timing, etc.:
WARNING: could not create /chosen FDT_ERR_NOSPACE.
ERROR: /chosen node create failed - must RESET the board to recover.

解决方法 make ARCH=powerpc mpc8315erdb.dtb DTS_FLAGS="-S65536"