急急急,2811

mouseatbj

谁调过2811,快来救命呀

charlesc

老兄是什么问题？

mouseatbj

用4ESW模快,为何在SH RUN

mouseatbj

在SH RUN 时看不到此块的信息?如何调试它呢,谢谢

wonderliang

sh ver
看看模块有无问题

mouseatbj

看不到这个模块的任何信息

mouseatbj

只能看到路由器自带的两口快速以太口,晕死了,还望指教

mouseatbj

发一下show  :
Apr  6 17:47:55.263: %SYS-5-CONFIG_I: Configured from console by consoleer
2800 Software (C2800NM-IPBASE-M), Version 12.3(T6, RELEASE SOFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Compiled Wed 29-Dec-04 15:07 by hqluong

ROM: System Bootstrap, Version 12.3(8r)T7, RELEASE SOFTWARE (fc1)

Router uptime is 19 minutes
System returned to ROM by power-on
System image file is "flash:c2800nm-ipbase-mz.123-8.T6.bin"

Cisco 2811 (revision 53.51) with 253952K/8192K bytes of memory.
Processor board ID FHK0904F4AY
2 FastEthernet interfaces
DRAM configuration is 64 bits wide with parity enabled.
239K bytes of non-volatile configuration memory.
62592K bytes of ATA CompactFlash (Read/Write)

Configuration register is 0xC0

cnadl

wic-4esw还是hwic-4esw，前者不支持

mouseatbj

是后者,搞不明白为什么,不会是IOS版本低吧??