AC Line status:
Line A0 Present
Line A1 Present
Line B0 Present
Line B1 Present 如何解决,前面板光驱下面两电源模块加电灯不亮,电源正常,急盼指点。作者: ts99 时间: 2008-02-29 18:24
1你将光驱下的两个pci power模块 互换一下,重启机器,看能不能起来机器。
2.你把你的ps命令的所有信息贴到论坛上,你上诉信息不够判断。还有mp日志多贴一些作者: qqbbs5252 时间: 2008-03-03 11:33 标题: 回复 #2 ts99 的帖子 是的,我贴的信息不够全面,PIC模块互换重启也不行,加电PIC模块灯不亮,试着手动给io chassis加电,则PIC模块正常,但还是启动不了,和正常机器一比较发现cell板没上电,手动给cell板加电失败,确定是cell板坏了,至少是CELL板电源模块坏了,能这么确定没吗?
[uninitialized] MP:CM> pe
This command controls power enable to a hardware device.
T - Cabinet
C - Cell
D - DVD/Tape
P - IO Chassis
R - Partition
Select Device: c
Enter cell number: 1
The power state is OFF for Cell 1.
In what state do you want the power? (ON/OFF) on
Error attempting to power ON : RtnCodeFailure
T - Cabinet
S - System Backplane
G - MP (Core I/O)
P - IO Chassis
C - Cell
Select Device: c
Enter cell number: 1
HW status for Cell 1 : FAILURE DETECTED
Power status : OFF, no fault
Boot is blocked
PDH memory is not shared
Processor Compatibility : FAULT
RIO cable status : UNDEFINED
RIO cable connection physical location : cannot be determined
Core cell is INVALID
Attention Led is off
PDHC status Leds : ----
CPU Module Slot 0 1 2 3
Populated
Local 48V Good
Power Enabled
Power Good
Front Side Bus Freq. : 250 MHz
CPU Core Freq. : 0 MHz
CPU Part Number :
System Boot Rom (SFW) firmware rev 0.000
PDH controller (PDHC) firmware rev 0.000, built THU JAN 01 00:00:00 1970
MICE revision is 0.0
[uninitialized] MP:CM> df
This command displays the FRU ID information for the selected FRU.
Do you want a specific FRU or a dump? ([S]/D)
B - Bulk Power Supply
G - Management Processor (Core I/O)
S - System Backplane
P - PCI Backplane
I - PCI Power Module
M - Mass Storage Backplane
L - LAN/SCSI card
C - Cell Board
H - Cell Board Controller (PDHC)
U - Cell Board Processor Module (PIROM)
X - Cell Board Processor Module (FRU)
Y - Cell Board Processor Power Module (PPM)
D - Cell Board Memory (DIMM)
Select FRU : c
Enter cell number: 1
The Entity you have selected is Cell Board
ERROR: There has been an error getting FRU: RtnCodeBusBoyDevTimeout