标题: warning [打印本页] 作者: zlhgood 时间: 2007-05-02 23:41 标题: warning 上面的问题是什么原因?怎样解决?作者: zlhgood 时间: 2007-05-02 23:43 标题: buchong WARNING: A geometry of 155009/16/63 for ad6 is incorrect. Using │
│a more likely geometry. If this geometry is incorrect or you │
│are unsure as to whether or not it's correct, please consult │
│the Hardware Guide in the Documentation submenu or use the │
│(G)eometry command to change it now. │
│ │
│Remember: you need to enter whatever your BIOS thinks the │
│geometry is! For IDE, it's what you were told in the BIOS │
│setup. For SCSI, it's the translation mode your controller is │
│using. Do NOT use a ``physical geometry''. │
├───────────────────────────────────────────────────────────
选择分区后格式化时的报警：
┌─────────────────── User Confirmation Requested ────────────────────┐
│ WARNING: This should only be used when modifying an EXISTING │
│ installation. If you are installing FreeBSD for the first time │
│ then you should simply type Q when you're finished here and your │
│ changes will be committed in one batch automatically at the end of │
│ these questions. If you're adding a disk, you should NOT write │
│ from this screen, you should do it from the label editor. │
│ │
│ Are you absolutely sure you want to do this now? │
├────────────────────────────────────────────────────────────────────┤
│ [Yes] No │
└────────────────────────────────────────────────────────────────────┘
┌──────────────── Message ─────────────────┐
│ ERROR: Unable to write data to disk ad6! │
│├──────────────────────────────────(100%)──┤
└ │ [ OK ] │
└─────────[ Press enter or space ]─────────┘