- 论坛徽章:
- 0
|
To configure a static IP address using the ARP Ping utility, follow these steps:
1. Obtain the iLO MP MAC address. To set the IP address using ARP, you must know the MAC address of the iLO MP LAN. You can find the MAC address of the iLO MP LAN on a label on the server.
IMPORTANT: Make sure you obtain the MAC address to the iLO MP LAN and not the MAC address to the server core LAN.
2. Verify that an active LAN cable on the local subnet is connected to the iLO MP LAN port on the server.
3. Access a PC on the same physical subnet as the server.
4. Open a DOS window on the PC.
5. At the DOS prompt, enter arp -s to assign the IP address to the iLO MAC address.
Syntax
arp -s <IP address you want to assign to the iLO MAC address> <iLO MAC address>
Example from Windows
arp -s 192.0.2.1 00-00-0c-07-ac-00
6. At the DOS prompt, enter ping followed by the IP address to verify that the iLO MP LAN port is configured with the appropriate IP address. The destination address is the IP address that is mapped to the iLO MAC address. Perform this task from the PC that has the ARP table entry.
Syntax
ping <IP address just assigned to the iLO MAC address>
Example from Windows
ping 192.0.2.1
7. Use this IP address to connect to the iLO MP LAN.
8. Use Web or telnet access to connect to the iLO MP from a host on the local subnet and complete the rest of the LAN parameter (gateway, subnet). |
|