机器上接了一个scsi硬盘盒 我要怎么才能找到？

jaix

#cfgmgr -v

jaix

From your #lscfg output,I find your 170 only have self inner scsi device (scsi0 scsi1),
+ scsi0            P1/Z1     Wide/Ultra-2 SCSI I/O Controller
+ scsi1            P1/Z2     Wide/Ultra-2 SCSI I/O Controller

and your hdisk0 and hdisk1 are connected to the scsi0.
+ hdisk0           P1/Z1-A2  16 Bit LVD SCSI Disk Drive (18200 MB)
+ hdisk1           P1/Z1-A6  16 Bit LVD SCSI Disk Drive (18200 MB)

do you connect the disk box to the scsi1 which port is on the back of 170 ?
please use command :
#cfgmgr -l scsi1

if you can't configure out the new disk in the box,
please check your scsi cable and disk box,
Maybe one of them is bad.

jaix

From your #lscfg output,
can't find any other scsi port,
scsi0 and scsi1 are your system self port,

check your scsi adapter,it didn't been configure on your system.

jaix

#lsdev -C |grep scsi
iscsi0     Available               iSCSI Protocol Device
scsi0      Available 10-60         Wide/Ultra-2 SCSI I/O Controller
scsi1      Available 10-61         Wide/Ultra-2 SCSI I/O Controller
scsi2      Available 20-58-00      Ultra320 SCSI RAID Adapter Physical bus
scsi3      Available 20-58-01      Ultra320 SCSI RAID Adapter Physical bus

if your system can configure the scsi adapter well,you can see the scsi2 or scsi3.

jaix

the cause maybe your scsi card is bad.