- 论坛徽章:
- 0
|
我在P550新装操作系统,但重启后系统报错如:
-------------------------------------------------------------------------------
Welcome to AIX.
boot image timestamp: 22:54 12/29
The current time and date: 15:18:52 12/30/2005
number of processors: 4 size of memory: 7808MB
boot device: /pci@800000020000003/pci@2,4/pci1069,b166@1/scsi@0/sd@3,0
kernel size: 13352175; 64 bit kernel
-------------------------------------------------------------------------------
0514-440 cfgcon: failed to create log file: check path name, permissions, and available space
DIAGNOSTIC OPERATING INSTRUCTIONS
LICENSED MATERIAL and LICENSED INTERNAL CODE - PROPERTY OF IBM.
(C) COPYRIGHTS BY IBM AND BY OTHERS 1982,1991-1995.
ALL RIGHTS RESERVED.
These programs allow you to enter diagnostics, service aids, single
user mode, or low-level maintenance mode. The diagnostics should be
used whenever problems with the system occur which have not been
corrected by any software application procedures available.
In general, the diagnostics will run automatically. However, sometimes
you will be required to select options, inform the system when to
continue, do simple tasks, and exchange diskettes.
Several keys are used to control the diagnostics:
- The Enter key continues the procedure or performs an action.
- The Backspace key allows keying errors to be corrected.
- The cursor keys are used to select an option.
To continue, press Enter.
FUNCTION SELECTION
1. Diagnostic Routines
This selection will test the machine hardware. Wrap plugs and
other advanced functions will not be used.
2. Advanced Diagnostic Routines
This selection will test the machine hardware. Wrap plugs and
other advanced functions will be used.
3. Task Selection(Diagnostics, Advanced Diagnostics, Service Aids, etc.)
This selection will list the tasks supported by these procedures.
Once a task is selected, a resource menu may be presented showing
all resources supported by the task.
4. Resource Selection
This selection will list the resources in the system that are supported
by the diagnostic programs. Once a resource is selected, a task menu will
be presented showing all tasks that can be run on the resource(s).
5. Single User Mode
The system will enter single-user mode for software maintenance.
To make a selection, type the number and press Enter [1]:5
如何解决?请高手执教。 |
|