- 论坛徽章:
- 0
|
Each drive in a logical library can be a control path drive. The control path for robot is enable at both of tape drives, so Atape driver configured the two logical libraries (smc0 and smc1) which point to same a physical library.
Do you purchase the Control path failover feature from IBM? If so, the setup is a requirement to allow to failover from one path to the other path, when a path fails to work. If no, go to the Operator Panel: Setup → Control Path Use this menu item to disable the control path drive at the highest driver. The lowest drive physically in a logical library is automatically set as the control path drive for that logical library. And then, power cycle the library and run # cfgmgr to reconfigure the AIX system. |
|