[请教]pix升级操作和文件管理

imking

本来想把pix 535的os从6.3升级到7.2的，copy tftp flash时候提升flash空间不足，
本来想看看flash里面有什么文件的，结果sh flash 压根就没用给出文件列表，
iso下的dir/del等命令在pix里面都用不了，真是烦恼啊


哪位兄弟姐妹做过pix升级的，请指点一下具体怎么做。

还有，pixos 6.3文件管理是怎么做？ cisco 下的 config guide 没用看打这方面的东西。
我想列一下flash的文件列表，还有如何删除文件

[ 本帖最后由 imking 于 2007-12-18 19:33 编辑 ]

imking

没有人来守望相助吗？？

海天一色

ERASE FILENAME

jordi

Quote from cisco.com

Important Notes
•If you are upgrading from a PIX 515 or a PIX 535 with PDM already installed, you must upgrade from monitor mode. See the instructions in the "Upgrading in Monitor Mode" section.

•The PIX Version 6.3 image on a PIX 515 or PIX 535 only accesses the first 8 MB of Flash memory, instead of the entire 16 MB of Flash. If the PIX Security appliance Version 7.0 image in combination with the Flash memory contents exceeds the 8 MB limit, following error message may result: Insufficient flash space available for this request. The solution is to load the image from monitor mode. See the "Upgrading in Monitor Mode" section.

•The PDM image in Flash memory is not automatically copied to the new filesystem. For information about installing ASDM (which replaces PDM on Version 7.0), see the ASDM Release Notes.

•To avoid installation failures, make sure that you have read the "Prerequisites to Upgrading" section before proceeding.

•See the "Upgrade Examples" section for configuration examples. These will be useful to review before you start your upgrade procedure.

jordi

补充：

upgrade完，记得再把bin文件从tftp copy到pix，因为之前是读到ram里面的，reload之后就没有了。

happyboygd

pix 635是没有erase flash命令的，必须到monitor模式下升级才行。


升级到721就有erase命令了。

273131

学习中,呵呵