做完POST后没有明显报错，但是有Board Descriptor (%o2): ffdfffff0bd11111

glfeng

hi，all

今天我给E450检测，跟换备件，CPU FAN 和 DISK FAN，做POST时，有如下输出，请问是哪里有问题，谢谢

Network Link Setup Failed.
Please Check Cable and Try Again.
Timeout waiting for ARP/RARP packet
Setting up Network Link and Speed.
Using Onboard Transceiver - Timeout waiting for AutoNegotiation Status to be updated.
Timeout reading Link status. Check cable and try again.
Timeout waiting for AutoNegotiation Status to be updated.
Timeout reading Link status. Check cable and try again.
Timeout waiting for AutoNegotiation Status to be updated.
Timeout reading Link status. Check cable and try again.
AutoNegotiation Timeout.
Check Cable or Contact your System Administrator.
Link Down.
Network Link Setup Failed.
Please Check Cable and Try Again.
Setting up Network Link and Speed.
Using Onboard Transceiver - Timeout waiting for AutoNegotiation Status to be updated.
Timeout reading Link status. Check cable and try again.
Timeout waiting for AutoNegotiation Status to be updated.
Timeout reading Link status. Check cable and try again.
Timeout waiting for AutoNegotiation Status to be updated.
Timeout reading Link status. Check cable and try again.
AutoNegotiation Timeout.
Check Cable or Contact your System Administrator.
Link Down.
Network Link Setup Failed.
Please Check Cable and Try Again.
Timeout waiting for ARP/RARP packet
Setting up Network Link and Speed.
Using Onboard Transceiver - Timeout waiting for AutoNegotiation Status to be updated.
Timeout reading Link status. Check cable and try again.

{1} ok
{1} ok
{1} ok show-post-results
Power On Selftest not run on last reset
Persistent/saved POST results are:
Status 0=Pass, Non-Zero=Fail (%o0): 0
Message String               (%o1):
Board Descriptor             (%o2): ffdfffff0bd11111
{1} ok

Snowict

从信息中没有看到明显的错误报告。 请先修改EEPROM参数再POST 机器。
diag-switch? true
auto-boot? false
diag-level? max

power-recycle the E450

glfeng

prom 几个参数我都该了，而且POST4，5遍都不行，是主办有问题么？

nimysun

tatus 0=Pass, Non-Zero=Fail (%o0): 0

返回值为0吧，
你的硬件没有什么问题吧。