B16及B32光纤交换机使用点滴及激活

mithara

B16/B32的光纤交换机，配置起来很简单，用WEB连接 10.77.77.77  登陆用户名 admin 密码 password,登陆后就按提示操作即可
当连通光纤后，在ZONE中把所有的口或者所有主机光纤卡的WWN号划分到一个ZONE中，才可以正常使用
如果发现默认激活的PORT不满足网络连接要求时，就需要激活未用的光口。具体方法如下
1、确信有已购买过激活协议
2、记录主机的WWN号，激活协议的Transaction Key License 主机序列号
3、登陆
http://ibm.com/storage/key
中注册。得到license，然后按照下面提示的installation guide 安装。激活后即可使用。
有的时候，在划分ZONE时，已与主机相连，但无法识别到主机光纤卡的WWN号，这时，需要到主机端，把光纤卡删除重新cfgmgr即可，方法如下
rmdev -dl fcs0 -R
rmdev -dl fcs1 -R
cfgmgr



Installation Guide

Note: The following instructions assume the switch has been attached to a network and is accessible from your PC or workstation.  

Via telnet

Connect to the switch via telnet session from a terminal emulation program initiated on a PC or workstation on your network.
Type the command: telnet [switch IP address]. When prompted, enter Administrator User name and password.
After login, enter the command: licenseAdd "license-key" (quotes are needed for this command). Be sure to enter the license key value exactly as received.
Check the status of installed license features by entering the command: licenseShow. This command displays a list of all licensed features enabled on the switch.

From a web browser (via GUI)

Connect to the switch with your browser. From the Switch view, select the Admin button.
When prompted, enter administrator user name and password.
On successful login, you will be presented the Admin screen, select the License Admin tab, Enter the new License Key. Be sure to enter the license key value exactly as received.
Select the Add License button.


To validate that this LicenseKey has been installed


From front panel display - if your switch is a model with a front panel display, the WWN can be shown on the display. Select the following command sequence: Status Menu > WorldWide Menu.


Further information


Consult the manual for the feature you are installing for further information on installation and answers to specific questions on the application.


Troubleshooting Guide

The license key is not accepted. Validate that the license key was entered exactly as received with no extraneous characters and following the correct use of capital and non capital letters. Re-enter the key and re-type the command licenseShow.
The license key was accepted, but does not appear to be active. This error will occur if a license key was entered on a switch with a different World Wide Name than intended. Check the World Wide Name on the switch by using the command: switchShow
To obtain the World Wide Name of the switch:
Connect to the switch from a terminal emulation program via telnet [telnet (switch IP address)].
When prompted, enter the administrator user name and password.
Enter the command switchShow. This command displays information about the switch, including the WWN. The WWN is in the form 10:00:00:xx:xx:xx:xx:xx where 'xx' values are unique to each switch.


Select Continue to obtain additional activation keys or correct input errors; otherwise, you are done with this procedure.  


本文来自ChinaUnix博客，如果查看原文请点：http://blog.chinaunix.net/u/3154/showart_183451.html