- 论坛徽章:
- 0
|
How to Replace a Failed Disk Drive in a
Running Cluster
Use this procedure to replace a failed disk drive in a running cluster.
1. Does replacing the disk drive affects any LUN’s availability?
n If not, go to Step 2.
n If the replacement does affect LUN availability, remove the LUN(s) from volume
management control. For more information, see your Solstice DiskSuite or
VERITAS Volume Manager documentation.
2. Replace the disk drive in the disk array.
For the procedure on replacing a disk drive, see the Sun StorEdge D1000 Storage
Guide.
3. Run Health Check to ensure that the new disk drive is not defective.
For instructions on running Recovery Guru and Health Check, see the Sun StorEdge
RAID Manager User’s Guide.
4. Does the failed drive belong to a drive group?
n If the drive does not belong to a device group, go to Step 5.
n If the drive is part of a device group, reconstruction is started automatically. If
reconstruction does not start automatically for any reason, then select Reconstruct
from the Manual Recovery application. Do not select Revive. When reconstruction
is complete, go to Step 6.
5. Fail the new drive, then revive the drive to update DacStore on the drive.
For instructions on failing drives and manual recovery procedures, see the Sun
StorEdge RAID Manager User’s Guide.
6. If you removed LUNs from volume management control in Step 1, return the
LUN(s) to volume management control.
For more information, see your Solstice DiskSuite or VERITAS Volume Manager
documentation.
[ 本帖最后由 maike_xiao 于 2008-6-3 17:24 编辑 ] |
|
免费注册
楼主: l5205
发表于 2008-06-03 16:43
