IPv4 over IPv6 的配置

shijiang1130

IPv4 over IPv6 的配置
         
           
      
   
对于 Cisco 路由器，可以使用 GRE ipv6 实现 IPv4 over IPv6
◆环境：
router_A 联一个 192.168.1.0/24 的IPv4子网，
router_B 联一个 192.168.2.0/24 的IPv4子网，
router_A 和 router_B 之间是通过 ipv6 互联。
◆需求：
192.168.1.0/24 和 192.168.2.0/24 两个IPv4子网之间互通。
◆配置：
router_A 配置
ipv6 unicast-routing
interface Tunnel1
ip address 10.0.0.1 255.255.255.0
tunnel source 2001:DA8:8000:100::8
tunnel destination 2001:DA8:B8:100::2
tunnel mode gre ipv6
interface FastEthernet0/0
no ip address
duplex auto
speed auto
ipv6 address 2001:DA8:8000:100::8/64
ipv6 enable
!
interface FastEthernet0/1
ip address 192.168.1.1 255.255.255.0
duplex auto
speed auto
ip route 192.168.2.0 255.255.255.0 Tunnel1
ipv6 route ::/0 2001:DA8:8000:100::1
router_B 配置
ipv6 unicast-routing
interface Tunnel1
ip address 10.0.0.2 255.255.255.0
tunnel source 2001:DA8:B8:100::2
tunnel destination 2001:DA8:8000:100::8
tunnel mode gre ipv6
!
interface GigabitEthernet0/0
no ip address
duplex auto
speed auto
ipv6 address 2001:DA8:B8:100::2/64
ipv6 enable
!
interface GigabitEthernet0/1
ip address 192.168.2.1 255.255.255.0
duplex auto
speed auto
ip route 192.168.1.0 255.255.255.0 Tunnel1
ipv6 route ::/0 2001:DA8:B8:100::1
               
               
               

本文来自ChinaUnix博客，如果查看原文请点：http://blog.chinaunix.net/u/15010/showart_505956.html