cisco 2960端口问题

liyoujunlizi

上面没有什么不正常的...我都已经 check过了.等会我连上去,给你看吧.

liyoujunlizi

here it is:
cgd1-3-a#sh interfaces fa0/27
FastEthernet0/27 is up, line protocol is up (connected)
  Hardware is Fast Ethernet, address is 001b.5365.921b (bia 001b.5365.921b)
  MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation ARPA, loopback not set
  Keepalive set (10 sec)
  Full-duplex, 100Mb/s, media type is 10/100BaseTX
  input flow-control is off, output flow-control is unsupported
  ARP type: ARPA, ARP Timeout 04:00:00
  Last input never, output 00:00:01, output hang never
  Last clearing of "show interface" counters 21:22:58
  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
  Queueing strategy: fifo
  Output queue: 0/40 (size/max)
  5 minute input rate 0 bits/sec, 0 packets/sec
  5 minute output rate 0 bits/sec, 0 packets/sec
     192 packets input, 30763 bytes, 0 no buffer
     Received 192 broadcasts (0 multicast)
     0 runts, 0 giants, 0 throttles
     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
     0 watchdog, 28 multicast, 0 pause input
     0 input packets with dribble condition detected
     0 packets output, 0 bytes, 0 underruns
     0 output errors, 0 collisions, 2 interface resets
     0 babbles, 0 late collision, 0 deferred
     0 lost carrier, 0 no carrier, 0 PAUSE output
     0 output buffer failures, 0 output buffers swapped out

PC上显示的状态是只有发包,没有收包.

谢谢shawnlee

liyoujunlizi

交换机的口是10/100自适应的呀.

liyoujunlizi

好的...