MQPUT error, reason code is 2085

koby223

Sorry that I can not key in Chinese.

An error occurs when calling MQPUT1 procedure, the reason code is 2085 - Unknow object name.
Here's the Q detail.
The alias Q has been connected successfully, the target Q of this alias Q is under another MQ manager, and my profile has no authority to even display. But the authority of the alias Q is fine, so deos the alias Q manager. Besides, no cluster for this alias Q. Could anyone advise whether the problem is due to this Q setting?

However, I try call 'QMQM' to perform the MQPUT with the same Q, it successfully done. Refer to the MQ reference guideline, it said it's because the the ObjectName field in the object descriptor is not recognized for the specified object type. This type is 1 is both QMQM and MQPUT1, not sure why it's successful in QMQM but in MQPUT1.

Appreciate if there's someone could advise!

digitalchina

MQRC_UNKNOWN_OBJECT_NAME
(2085, X'825') Unknown object name.
On an MQOPEN or MQPUT1 call, the ObjectQMgrName field in the object
descriptor MQOD is set to one of the following:
v Blank
v The name of the local queue manager
v The name of a local definition of a remote queue (a queue-manager
alias) in which the RemoteQMgrName attribute is the name of the local
queue manager
However, the ObjectName field in the object descriptor is not recognized for
the specified object type
This reason code can also occur when the queue is a cluster queue that is
hosted on a remote queue manager, but the local queue manager does not
have a defined route to the remote queue manager.
See also MQRC_Q_DELETED.
Corrective action: Specify a valid object name. Ensure that the name is
padded to the right with blanks if necessary. If this is correct, check the
queue definitions