- 论坛徽章:
- 0
|
今天装了一个solaris10 x86,安装完成后,发现网卡一直装不上,我用的网卡是“VIA Networking Velocity Family Gigabit Ethernet Adapter”,安装后,配置hostname.gets0的时候,重启总是提示gets0安装错误。请教一下高人。这个问题如何解决。
以下就是安装步骤
**
**
** VIA Networking Velocity Family Gigabit Ethernet Adapter
**
** Solaris 8/9
**
** v1.10 Oct. 2004
**
**
Introduction:
=============
This document describes the procedure to install the Solaris 8/9 driver for
"VIA Networking Velocity Family Gigabit Ethernet Adapter".
Contents of the Subdirectory:
=============================
gets.pkg The ethernet driver for Solaris 8/9.
solaris.txt This file.
Installation:
=============
Solaris 8/9
Installing driver procedure on Solaris 8/9 :
-----------------------------------------
Before you start with the installation process, make sure that the
Solaris 8/9 system is properly installed. Similarly, your adapter
should also be properly installed in your machine.
1. Installation Diskette in DOS format.
Put the "VIA Networking Velocity Family Gigabit Ethernet Adapter" Solaris 8/9 Driver
diskette to floppy A: and use mcopy command to copy Driver into
Solaris's directories.
# volcheck
# cp /floppy/floppy0/gets.pkg /tmp
2. Run 'pkgadd' utility to add the driver software to system.
# pkgadd -d /tmp/gets.pkg
=> Select "1 gets VIA Networking Velocity Family Gigabit Ethernet Adapter Driver"
to add the driver package to the system.
=> quit
3. Create or rename the /etc/hostname.XXX# to /etc/hostname.gets#
The '#' of filename /etc/hostname.getsX is the instance number of
driver. You can find this instance by examine the output of program
'dmesg'.
4. Shutdown and reboot the system.
# cd /
# sync;sync;reboot
NOTE:
1. This driver can support up to four network adapters.
[ 本帖最后由 hklstore 于 2009-2-5 18:41 编辑 ] |
|