免费注册 查看新帖 |

Chinaunix

  平台 论坛 博客 文库
12下一页
最近访问板块 发新帖
查看: 11924 | 回复: 10
打印 上一主题 下一主题

cisco和华为trunk配不通?!?? [复制链接]

论坛徽章:
0
跳转到指定楼层
1 [收藏(0)] [报告]
发表于 2009-04-09 22:25 |只看该作者 |倒序浏览
这两者 之间配置trunk需要注意些什么呀?

论坛徽章:
0
2 [报告]
发表于 2009-04-10 00:38 |只看该作者
cisco trunk口封装要使用802.1q而不是默认的isl

论坛徽章:
0
3 [报告]
发表于 2009-04-10 08:55 |只看该作者
isl是cisco私有的协议
华为的设备和思科的设备之间配置trunk只能选择.1Q
还没有试过是不是能配置

论坛徽章:
5
IT运维版块每日发帖之星
日期:2015-08-06 06:20:00IT运维版块每日发帖之星
日期:2015-08-10 06:20:00IT运维版块每日发帖之星
日期:2015-08-23 06:20:00IT运维版块每日发帖之星
日期:2015-08-24 06:20:00IT运维版块每日发帖之星
日期:2015-11-12 06:20:00
4 [报告]
发表于 2009-04-10 09:11 |只看该作者
没特别注意的啊。都是DOT1Q就通了。

另外如果不通注意速率协商,还有STP问题了。

论坛徽章:
0
5 [报告]
发表于 2009-04-10 10:50 |只看该作者
贴出您的配置看看吧。

论坛徽章:
0
6 [报告]
发表于 2009-04-10 13:07 |只看该作者
协议封装都是dot 1q
cisco2960   配置:
interface FastEthernet0/13                    与H3C S5600连接
switchport mode trunk                          已配置 switchport trunk vlan all
speed 100
duplex full

华为S5600:
#
interface GigabitEthernet1/0/4
duplex full
speed 100
port link-type trunk
port trunk permit vlan all
description connect LuNan-test-DAS
#

[ 本帖最后由 deeperbluer 于 2009-4-10 13:09 编辑 ]

论坛徽章:
5
IT运维版块每日发帖之星
日期:2015-08-06 06:20:00IT运维版块每日发帖之星
日期:2015-08-10 06:20:00IT运维版块每日发帖之星
日期:2015-08-23 06:20:00IT运维版块每日发帖之星
日期:2015-08-24 06:20:00IT运维版块每日发帖之星
日期:2015-11-12 06:20:00
7 [报告]
发表于 2009-04-10 13:13 |只看该作者
帖接口统计状态,生成树状态。

另外中间是通过网线直连还是有别的转换设备。

论坛徽章:
0
8 [报告]
发表于 2009-04-10 13:25 |只看该作者

回复 #7 ssffzz1 的帖子

原本是要通过30M带宽的城域网,因为不通,所以现在测试下是不是应为这个带宽引起的不通 ,所以直接把设备拿到一起了,现在是直接平行线连接两台设备。

请问“帖接口统计状态,生成树状态怎么看?!”
请分别介绍下cisco和华为的查看命令!谢谢

[ 本帖最后由 deeperbluer 于 2009-4-10 13:27 编辑 ]

论坛徽章:
5
IT运维版块每日发帖之星
日期:2015-08-06 06:20:00IT运维版块每日发帖之星
日期:2015-08-10 06:20:00IT运维版块每日发帖之星
日期:2015-08-23 06:20:00IT运维版块每日发帖之星
日期:2015-08-24 06:20:00IT运维版块每日发帖之星
日期:2015-11-12 06:20:00
9 [报告]
发表于 2009-04-10 13:30 |只看该作者
1、用交叉线。
2、
show interface f0/13 接口统计。

Show spann 后面忘记了。自己?吧。

论坛徽章:
0
10 [报告]
发表于 2009-04-10 16:39 |只看该作者

回复 #9 ssffzz1 的帖子

Switch#   sho int f0/13
FastEthernet0/13 is up, line protocol is up (connected)
  Hardware is Fast Ethernet, address is 0022.0c68.980d (bia 0022.0c68.980d)
  MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation ARPA, loopback not set
  Keepalive set (10 sec)
  Full-duplex, 100Mb/s, media type is 10/100BaseTX
  input flow-control is off, output flow-control is unsupported
  ARP type: ARPA, ARP Timeout 04:00:00
  Last input 00:00:00, output 00:00:00, output hang never
  Last clearing of "show interface" counters never
  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
  Queueing strategy: fifo
  Output queue: 0/40 (size/max)
  5 minute input rate 8000 bits/sec, 4 packets/sec
  5 minute output rate 1000 bits/sec, 1 packets/sec
     6818 packets input, 1211370 bytes, 0 no buffer
     Received 6810 broadcasts (0 multicasts)
     0 runts, 0 giants, 0 throttles
     73 input errors, 73 CRC, 0 frame, 0 overrun, 0 ignored
     0 watchdog, 3818 multicast, 0 pause input
     0 input packets with dribble condition detected
     3121 packets output, 257065 bytes, 0 underruns
     0 output errors, 0 collisions, 1 interface resets
     0 babbles, 0 late collision, 0 deferred
     0 lost carrier, 0 no carrier, 0 PAUSE output
     0 output buffer failures, 0 output buffers swapped out
您需要登录后才可以回帖 登录 | 注册

本版积分规则 发表回复

  

北京盛拓优讯信息技术有限公司. 版权所有 京ICP备16024965号-6 北京市公安局海淀分局网监中心备案编号:11010802020122 niuxiaotong@pcpop.com 17352615567
未成年举报专区
中国互联网协会会员  联系我们:huangweiwei@itpub.net
感谢所有关心和支持过ChinaUnix的朋友们 转载本站内容请注明原作者名及出处

清除 Cookies - ChinaUnix - Archiver - WAP - TOP