- 论坛徽章:
- 0
|
copy 了一下，将就看吧
Use the following steps to replace the ECB.
1. Connect a PC or terminal to the maintenance port of the controller with the ECB that
needs replacement.
The controller connected to the PC or terminal becomes “this controller.”
2. Enter the following command to verify that system time is set:
SHOW THIS_CONTROLLER FULL
If system time is not set or current, enter the current time using the following
command:
SET THIS_CONTROLLER TIME=dd-mmm-yyyy:hh:mm:ss
3. Start FRUTIL with the following command:
RUN FRUTIL
4. Enter Y(es) to confirm the intent to replace the “this controller” ECB.
CAUTION: Make sure to install the replacement ECB in a bay that supports the same
cache module as the current ECB being removed—ECB bay A1 and A2 are paired and
ECB bay B1 and B2 are paired.
Remove the blank bezel from this replacement bay and reinstall the blank bezel in the
bay vacated by the ECB being replaced. Failure to reinstall the blank bezel might
cause an overtemperature condition and damage the enclosure.
5. Install a Battery Service Label on the replacement ECB as described by the Compaq
StorageWorks Battery Service Label Placement installation card.
NOTE: The Battery Service Label indicates the installation date (MM/YY) for the replacement
ECB.
6. Remove the blank bezel from the appropriate bay and insert the replacement ECB.
IMPORTANT: Do not remove the old ECB until the ECB charged LED on the replacement ECB
turns ON (see Figure 3–9, 1).
Figure 3–9. ECB status LEDs
7. Remove the old ECB and install the blank bezel in this vacant bay.
8. Press Enter/Return.
❏ The ECB expiration date and deep discharge history are updated.
❏ FRUTIL exits.
9. Disconnect the PC or terminal from the controller maintenance port.
10. Repeat step 1 through step 9 to replace another ECB for the “other controller” in a |
|
免费注册
发表于 2009-05-08 16:42
发表于 2009-05-10 01:22
