- 论坛徽章:
- 0
|
关于系统微码请教!!!
[quote]原帖由 "johnsons"]ibm6000,能否详细说说如何进串口升微码,或者在那一份资料上?不吝赐教。。。。[/quote 发表:
6.3 Using the Service Processor Menu Method
Service Processor Menus allow updating from diskettes only.
Note: All firmware (System, Service Processor and SPCN) will be updated when using this method.
Note: Access to the Service Processor Menus is not available on serial port (S4).
a. Power on or shutdown and restart the system.
b. When the operator panel on the server says OK, press Enter, to bring up the Service Processor
Menu.
c. Choose 1 for Service Processor Setup Menu. <Enter>;
d. Choose 7 for Reprogram Flash EPROM Menu. <Enter>;
e. Type y to continue. <Enter>;
f. Follow on-screen update steps as they are presented.
g. The 'Rebooting Service Processor ' message appears on the screen.
h. Begin watching the operator panel.
i. When the panel says 'OK', press Enter.
The Service Processor Menu appears on your screen.
The second line of the title, Version: CM020916, should match the firmware level you just
installed.
j. To restart AIX, choose 2 for System Power Control Menu. <Enter>;
k. Choose 4 for Power-On System. <Enter>;
l. Type y to confirm. <Enter>;
If you confirm, the server will reboot and return to the AIX prompt. This may take ten to thirty minutes (or more), depending on the configuration of your target server. Since the update occurs during this shutdown/reboot sequence, it is important to protect the server from interruptions. The checkpoints 99FF and 99FD alternately appear while the update is in progress.
Don't forget to retrieve and file any firmware update diskette that may still be in the system's diskette drive. A good time to do this is after the reboot has completed.
Your firmware update is complete. |
|