安装5.3机器无法启动了

davis1220

前几天我也遇到了，升了微码就好了。同样的机型做同样的事。

bbbyang

Update system firmware !
*Table 2.1:  Firmware Update Descriptions and History*
*3F080425*         _IMPACT_:   Serviceability     _SEVERITY_:   Special Attention

    * A problem was fixed that caused the time-of-day clock to gain one
      second every time the system or partition was rebooted.

*3F070425*         _IMPACT_:   Serviceability     _SEVERITY_:   Special Attention

    * A problem was fixed that caused a failure with error code 20EE000B
      when upgrading to later AIX versions with large boot images.
    * A problem was fixed that caused Linux to fail to boot if there
      were more that 256 characters in the boot string.

*3F061030*         _IMPACT_:   Serviceability     _SEVERITY_:   Special Attention

    * Aproblem was fixed that caused the ring indicate power-on function
      (in the service processor menus) to power on the system even
      though it was set to "disabled".
    * A problem was fixed that caused the system to hang at E52A when
      rebooted after SRC B1274634 ("SPCN loop fault") was reported.

*3F060917*         _IMPACT_:   Serviceability     _SEVERITY_:   Special Attention

    * A problem was fixed that was causing the calls to system firmware
      to set the time-of-day clock to take too long and prevent
      interrupts on single processor systems.  This can cause adapter
      errors due to overruns which may result in hangs or retries
      depending on the adapters and system activity.

*3F060626*         _IMPACT_:   Serviceability     _SEVERITY_:   Special Attention

    * A problem was fixed that was causing enhanced error handling (EEH)
      error codes to be erroneously generated when certain adapter card
      configurations were heavily stressed by the application code.
    * A problem was fixed that was causing the system to crash when
      error data was retrieved.

*3F060109*         _IMPACT_:   Serviceability     _SEVERITY_:   Special Attention

    * Fixed a problem that was causing the AIX logical location codes of
      the Ethernet ports to be incorrect when several types of
      multi-port Ethernet adapter cards were replaced using the PCI
      hot-plug function.

*3F051101*         _IMPACT_:   Serviceability     _SEVERITY_:   Special Attention

    * The firmware was changed so that the time-out for firmware console
      selection is 60 seconds no matter how many devices are attached to
      the system or partition.
    * Firmware was updated to fix intermittent failures of the AIX
      command "shutdown -t" to power on.

*3F050715*         _IMPACT_:   Serviceability     _SEVERITY_:   Special Attention

    * Added support for address request protocol (ARP).
    * A problem was fixed that was causing the firmware to report an
      error on an I/O slot when no I/O adapter card was present.
    * A problem was fixed that was causing the PCI bus to report an
      error when a PCI adapter with a bridge on it was hot-plugged.
    * An invalid error code callout for clock errors was fixed.

*3F050607*         _IMPACT_:   Function    _SEVERITY_:   Programming Error

    * Corrects boot failure problem when an AIX sinstallation CD-ROM is
      booted twice in optical drive P/N 97P6883 when installed as part
      of FC 2640.
    * Fixes a problem that causes the system to crash when AIX tries a
      reset on a slot which is already in the reset state.

*3F050502*         _IMPACT_:   Serviceability    _SEVERITY_:   Special Attention

    * Improved isolation for Remote I/O (RIO) loop failures.
    * Corrects systemTime of Day gains observed after reboot.
    * Resolves incorrect cooling fan FRU callout posted by diagnostics.
    * Changed cooling fan high speed transition point to reduce fan
      noise on 9114-275 systems.

*3F050311*         _IMPACT_:   Serviceability    _SEVERITY_:   Special Attention

    * Corrects intermittent boot failure at checkpoint E1A9.
    * Corrects intermittent boot failure with error 101100AC after AC
      power interruption when Unattentd Start Mode is enabled.

*3F050131*         _IMPACT_:   Function      _SEVERITY_:   Special Attention

    * Change made to collect hypervisor dump as part of snap command.
    * Change made to mask interrupts for a specific slot if a problem is
      encountered with and I/O adapter.

*3F041029*         _IMPACT_:   Function      _SEVERITY_:   Special Attention

    * Added support for network boot when target server provides
      preferred gateway information in bootp reply.
    * Added support for PCI adapters that require additional memory I/O
      space (Future OEM vendor requirement).
    * Corrects network boot problems with IBM Gigabit Ethernet adapters
      (FC 2969).

*3F041021*         _IMPACT_:  Function      _SEVERITY_:  Programming Error

    * Added support for AIX 5.3.
    * Resolves issue of excessive length of time required to collect AIX
      dump for partitions with Service Authority assigned.
    * Corrects potential cause for system hang with error 40670EA1 on
      systems with Linux Operating System.