FreeBSD 7.2 无线配置 T43

llsx

环境：x86 FreeBSD7.2 IBM T43
默认内核已编译了iwi模块，直接加载使用即可，注意需要其他相关，在/boot/loader.conf添加一下内容：
legal.intel_iwi.license_ack=1
if_iwi_load="YES"
wlan_load="YES"
firmware_load="YES"
iwi_bss_load="YES"
iwi_ibss_load="YES"
iwi_monitor_load="YES"
wlan_amrr_load="YES"
wpifw_load="YES"
wlan_wep_load="YES"
wlan_ccmp_load="YES"
wlan_tkip_load="YES"
在/etc/rc.conf添加以下内容：
ifconfig_iwi0="up"
wlans_iwi0="wlan0"
ifconfig_iwi0="ssid Wireless wepmode on  weptxkey 1 wepkey lsar1 DHCP"
注意：Wireless是无线AP的ssid,"lsar1"这里是无线AP连接密码.配置好后重启即可
dmesg中会出现iwi加载信息
iwi0:  mem 0xa8401000-0xa8401fff irq 21 at device 2.0 on pci4
iwi0: Ethernet address: 00:13:ce:cc:7d:00
iwi0: [ITHREAD]
运行ifconfig iwi0
iwi0: flags=8843 metric 0 mtu 1500
 ether 00:13:ce:cc:7d:00
 inet 192.168.0.10 netmask 0xffffff00 broadcast 255.255.255.255
 media: IEEE 802.11 Wireless Ethernet autoselect (OFDM/24Mbps)
 status: associated
 ssid Wireless channel 6 (2437 Mhz 11g) bssid 00:23:cd:83:4e:72
 authmode OPEN privacy ON deftxkey 1 wepkey 1:40-bit bmiss 10
 scanvalid 60 bgscan bgscanintvl 300 bgscanidle 250 roam:rssi11g 7
 roam:rate11g 5 protmode CTS
无线网卡加载成功！
               

本文来自ChinaUnix博客，如果查看原文请点：http://blog.chinaunix.net/u/9816/showart_2127521.html