求助：急,solaris通过tip命令连接磁针

none311

通过串口线连接磁盘阵列好后
在solaris上机子上通过 tip -38400 /dev/ttyb
访问磁阵  显示connected 但是用control +L 无法访问 一直卡死在当前界面

none311

各位大虾不在？？

zhmzhouming

tip不是那么用的吧，起码也得改下/etc/remote文件啊：



Using Tip

Note: tip is available in SFU and Solaris /etc/remote can be used with it. Connect the appropriate serial cable from serial port on laptop (usually serial port 1) to serial port A on target Sun system.

Use "tip hardwire" (not "hardware" to open a connection to the headless box before booting it: From a Solaris shell prompt on the local system, issue the command:

    tip hardwire

    OR

    tip ser1

Notes

    * This is "tip hardwire" (not "tip hardware".
    * ser1 should be defined in  /etc/remote (see below)

hardwire is defined on Solaris in the /etc/remote to use port B (for laptop you need to correct this or add another line, see below):

    cuab:dv=/dev/cua/b:br#2400
    dialup1|Dial-up system:\
            :pn=2015551212:tc=UNIX-2400:
    hardwire:\
            :dv=/dev/term/b:br#9600:el=^C^S^Q^U^D:ie=%$e=^D:
    tip300:tc=UNIX-300:
    tip1200:tc=UNIX-1200:
    tip0|tip2400:tc=UNIX-2400:
    tip9600:tc=UNIX-9600:
    tip19200:tc=UNIX-19200:
    UNIX-300:\

If you need to connect from serial port A you need to modify this entry in /etc/remote or better add another entry, for example ser1 :

    ser1:\
            :dv=/dev/term/a:br#9600:el=^C^S^Q^U^D:ie=%$e=^D:

After tip session established you can boot the server. This tip session should be kept active as long as server remains online.
You should be connected. Press enter a few times to see if you are getting a response. If you are not, check your connections and make sure you have the right cable.

From within tip, you can access a tip menu by pressing ~? after a carriage return. To quit the tip session, press ~. and to send a break character, type ~#

To send a break character, type ~#


The hardwire parameter in the tip command refers to an entry in the file /etc/remote which describes the serial port connections. By default, hardwire specifies port B with 9600 baud, 8 data bits, no stop bits, and 1 parity bit. Connect, via a null modem, serial port "A" of the Sun to your terminal's serial port. Your terminal settings should be 9600 8N1, which are the default serial settings of the Sun.

If you use tip, if possible, emulate a SUNTERM.

zhmzhouming

格式有变化，你打开这个连接看看吧
http://www.softpanorama.org/Sola ... le_on_solaris.shtml

none311

改了/etc/remote
ss3310: :dv=/dev/term/b:br#38400:e1=^C^S^Q^U^D:ie=%$e=^D:
tip ss3310 出现的是同样的问题