ES45 OCP显示 bad RMC flash ，大家帮个忙！

lirongpu10

现运行的一台ES45（双电源）因一块电源掉电，重新拔插电源后不能恢复正常（未断电生启），正常断电重启后，OCP显示 “bad RMC flash ”，系统再无任何反应，请大家帮个忙分析一下！！谢谢。

seanding

如果不能进入>>>，试试软盘升级firmware

You can update the remote management console firmware from flash ROM
using the LFU.
1.  Load the update medium.
2.  At the UPD> prompt, exit from the update utility, and answer y to the
manual update prompt.  Enter update RMC to update the firmware.
UPD> exit
Do you want to do a manual update [y/(n)] y
***** Loadable Firmware Update Utility *****
-------------------------------------------------------------
Function    Description
-------------------------------------------------------------
Display     Displays the system’s configuration table.
Exit        Done exit LFU (reset).
List        Lists the device, revision, firmware name, and
update revision.
Readme      Lists important release information.
Update      Replaces current firmware with loadable data
image.
Verify      Compares loadable and hardware images.
? or Help   Scrolls this function table.
-----------------------------------------------------------
UPD> update RMC
.
.

lirongpu10

谢谢朋友的回复，用你说的方法试了，不行，换了主板，OK了。在此也多谢论坛里的朋友们！！！！

swallowcn

需要es45电源的话可以联系我们!