linux挂接盘阵错误

言论自由

一直用的好好的，从起之后挂接不上磁盘阵列的分区了。各位帮帮忙啊。
SCSI subsystem driver Revision: 1.00
scsi_register allocating 3820 bytes for FC HBA
ioremap'd Membase: f8834000
  HBA Tachyon RevId 2.0
Allocating 119808 for 576 Exchanges @ f6840000
Allocating 112904 for LinkQ @ f6820000 (576 elements)
Allocating 104456 for TachSEST for 512 Exchanges
  cpqfcTS: writing IMQ BASE 36860000h    PI 36864000h
  cpqfcTS: SEST f6800000(virt): Wrote base 36800000h @ f8834140
cpqfcTS: New FC port 000001h WWN: 500508B1000B55F0 SCSI Chan/Trgt 0/0
scsi0 : Compaq FibreChannel HBA Tachyon Chip/Board Ver??: WWN 500508B200505FB4
on PCI bus 6 device 0xa0fc irq 22 IObaseL 0x7000, MEMBASE 0xf7ef0000
PCI bus width 64 bits, bus speed 66 MHz
FCP-SCSI Driver v2.1.1
GBIC detected: Short-wave.  LPSM 0h Monitor
  Vendor: COMPAQ    Model: LOGICAL VOLUME    Rev: 2.60
  Type:   Direct-Access                      ANSI SCSI revision: 02
  Vendor: COMPAQ    Model: LOGICAL VOLUME    Rev: 2.60
  Type:   Direct-Access                      ANSI SCSI revision: 02
  Vendor: COMPAQ    Model: LOGICAL VOLUME    Rev: 2.60
  Type:   Direct-Access                      ANSI SCSI revision: 02
Attached scsi disk sda at scsi0, channel 0, id 0, lun 0
Attached scsi disk sdb at scsi0, channel 0, id 0, lun 1
Attached scsi disk sdc at scsi0, channel 0, id 0, lun 2
SCSI device sda: 1052819775 512-byte hdwr sectors (539044 MB)
Partition check:
sda: unknown partition table
SCSI device sdb: 1052819775 512-byte hdwr sectors (539044 MB)
sdb: unknown partition table
SCSI device sdc: 761834430 512-byte hdwr sectors (390059 MB)
sdc: unknown partition table
Compaq CISS Driver (v 2.4.27)
cciss: Device 0xb178 has been found at bus 1 dev 1 func 0
cciss: using DAC cycles
      blocks= 71122560 block_size= 512
      heads= 255, sectors= 32, cylinders= 8716
拜托了..

wolfop

sdc的分区表不正确。