nfs 问题求教

kelly_sh

我有一台solaris 的nfs server服务器，想共享给windows,solaris及linux使用。由于windows只支持nfs2和3，故将solaris上的nfs降级为nfs3，在windows上测试通过。但linux及solaris则无法mount，solaris执行showmount -e 及mount -o vers=3 10.1.1.1:/upload_all /upload_all均报 RPC: Rpcbind failure - RPC: Timed out，linux(redhat 5.4)则可以执行showmount -e ，但执行mount -t nfs 10.175.1.1:/upload_all /upload_all 报错timed out
将solaris上改为nfs4，则linux及solaris均可正常mount.
有没有办法让solaris及linux mount nfs3呢？

roger1402001

回复 1# kelly_sh

頂一下~~~~

   

ragecf

Linux上也加一个-o vers=3 试试呢？

roger1402001

回复 1# kelly_sh

Reference Installing Microsoft Windows Services for UNIX 3.5

If you are installing Windows Remote Shell service, Client for NFS, Gateway for NFS, Server for NFS, or the Base utilities, in the User Name Mapping box, do one of the following, depending on which is appropriate for your network configuration:

Click Remote User Name Mapping Server, type the name of the remote User Name Mapping server, and then click Next.

Click Local User Name Mapping Server, click Network Information Service (NIS), click Next, select the Windows domain, type the name of the NIS domain (and optionally, the NIS server name), and then click Next.

Click Local User Name Mapping Server, click Password and group files, click Next, type the fully qualified path names of the password and group files, select the Windows domain, and then click Next.

Note
If you click Local User Name Mapping Server, User Name Mapping is automatically installed and Windows Services for UNIX is configured to use the local computer (localhost) as the User Name Mapping server.

Important
Windows Remote Shell service, Client for NFS, Gateway for NFS, Server for NFS, and the Base utilities work properly only after you specify the name of the User Name Mapping server.

不知道是否有關聯,可以試看看在 windows 把 name of the User Name Mapping server給設定妥當.