求教make_recovery问题

spiderland

我运行下面命令：
     make_recovery -A -C,却返回下面错误结果：

#make_recovery -A -C
NOTE:    vgdisplay -v unsuccessful
NOTE:    vgdisplay -v unsuccessful
NOTE:    vgdisplay -v unsuccessful
NOTE:    vgdisplay -v unsuccessful
NOTE:    vgdisplay -v unsuccessful
NOTE:    vgdisplay -v unsuccessful

ERROR: Can\'t contact server 15.72.57.106.
***************************************
       HP-UX System Recovery
       Going to create the tape.
然后系统长时间不反映。

其中15.72.57.106根本不是我们公司内的IP地址。我不清楚是否使用了哪个默认的配置文件。另外VG信息为什么无法备份？刚接触HP-UX，请各位多指点。

Shad

原帖由 \"spiderland\" 发表：
我运行下面命令：
     make_recovery -A -C,却返回下面错误结果：

#make_recovery -A -C
NOTE:    vgdisplay -v unsuccessful
NOTE:    vgdisplay -v unsuccessful
NOTE:    vgdisplay -v unsuccessful
NOTE:    vgdisplay -v unsuccessful
NOTE:    vgdisplay -v unsuccessful
NOTE:    vgdisplay -v unsuccessful

ERROR: Can\'t contact server 15.72.57.106.
***************************************
       HP-UX System Recovery
       Going to create the tape.
然后系统长时间不反映。

其中15.72.57.106根本不是我们公司内的IP地址。我不清楚是否使用了哪个默认的配置文件。另外VG信息为什么无法备份？刚接触HP-UX，请各位多指点。

Hi,

make_recovery does take a long, long time to finish (at least 30min). The message \"Going to create the tape.\" message is last message you will see if you don\'t use the \"-v\" option in your command. It\'s normal to wait for 30min or longer before you see response again.

I am not sure the ERROR part. Are you sure all your network settings are correct? Check the /etc/hosts file, etc.

Good Luck.

kisa_lcx

check your /etc/hosts file

kevin7954

matching the

nslookup <your hostname>;
nslookup <your hostname IP>;

make sure this is in match