- 论坛徽章:
- 0
|
5. Create a \"Physical disk\" resource.
Note You may already have a physical disk resource created. If so, you will have to move this physical disk resource into the MS DTC group and go to the next step.
a. Right-click the MS DTC group, and then click New\\Resource.
b. Type a descriptive name such as MSDTC Physical disk.
c. In Resource Type, click Physical disk, click to select the MSDTC Group check box, and then click Next.
d. In Possible Owners, click Next unless you do not want MS DTC to run on a particular node.
e. In Dependencies, do not add any dependencies, and then click Next.
f. In Disk Parameters, click the physical disk that you will use for MS DTC.
g. Click Finish, and then click OK to confirm that the resource has been created.
6. Right-click the MS DTC Group, and then click New\\Resource.
7. Type a name, such as MSDTC Resource.
8. In Resource Type, click to select Distributed Transaction Coordinator, verify that the MSDTC Group is selected, and then click Next.
9. In Possible Owners, click Next unless you do not want MS DTC to run on a particular node.
10. In Dependencies, press and hold the CTRL key on the keyboard, select both the Physical Disk and Network Name that you created in step 2, and then click the Add button.
11. Click Finish, and then click OK to confirm that the resource has been created.
Note You should not put the MS DTC resource online before you follow the instructions in Microsoft Knowledge Base article 817064 to enable Network DTC Access.
12. Complete the steps that are documented in Knowledge Base article 817064.
13. Right-click the MSDTC Resource, and then click Bring Online. |
|