solaris 7的format问题

rolex

我有一颗seagate36g硬盘，想挂到我e450上，系统是solaris7，但是用format命令时，不能识别硬盘（在控制台可以看到），用solaris 8 光盘启动后，认到了，我将label存到文件format.dat， 并考到solaris 7 上。
在solaris 7中执行format -x /tmp/system.dat -d c1t2d0
可以看到36g盘，但是在label时，报INQUIRY错误。

bloomit

When you add to a disk to your hosts/server runing Solaris 7, If necessary, run \"[B]drvconfig;disks[/B]\" cmds to configure the new disks.Then you use \"format\", you will see the newly added disks...

As for your \"format\" error question,
# format
>partition
>label
>quit
>quit
Is there any question?

P.S.:
I think your have installed disk correctly on your E450. If your are not sure, At PROM\'s \"OK\" prompt, type \"probe-scsi-all\" to check if your disk is properly installed physically...(Don\'t forget to set auto-boot?=false first..)

rolex

最初由 bloomit 发布
[B]When you add to a disk to your hosts/server runing Solaris 7, If necessary, run \"[B]drvconfig;disks[/B]\" cmds to configure the new disks.Then you use \"format\", you will see the newly added disks...

As for your \"format\" error question,
# format
>partition
>label
>quit
>quit
Is there any question?

P.S.:
I think your have installed disk correctly on your E450. If your are not sure, At PROM\'s \"OK\" prompt, type \"probe-scsi-all\" to check if your disk is properly installed physically...(Don\'t forget to set auto-boot?=false first..) [/B]

thanks very much.

I think i forgot run disks cmd. let me try again.