- 论坛徽章:
- 0
|
If you have forgotten the password on the T300 storage system, you can do the following to gain access:
- Stop all I/O going to the T3(s).
- Connect console cable to a terminal and power off all
units (both trays in a partner group).
- Power master unit back on (leave alternate master off) and
interrupt the boot process by hitting RETURN when you see
this message:
\"hit the RETURN key within X seconds to cancel...\"
NOTE: If you leave the alternate master on, it will continue
to boot. Eventually it will assume there is a problem with
the master (that we interrupted), disable it, and make itself
the master. Not good...
- At the \"T300-EP\" prompt, use the \'set passwd\' command to
view (and memorize...) the password.
- Type \'reset\' to reboot, and immediately power on the alternate
master (if present).
- If you choose, you can change the password after it boots
with the \'passwd\' command.
NOTE: The T3 allows you to set the passwd at the \"T300-EP\"
prompt using the \'set passwd {newpasswd}\' string, and it will
appear to change it. But you may find after booting up that your
new password did not take. Again, not good...
 |
|
免费注册
发表于 2003-01-24 12:03
