X1155A，高速串口卡，那位高人用过，非常着急！

maxtp

X1155A，需要用这个卡连到路由器上，那位用过或知道的给讲讲，问了好多人，没有头绪，一个问题是能不能通过他连到路由器上？中间的连线是Sun就有，还是需要配第三方的，是怎样的一根线，如何连到V35的接口上，比较乱，呵呵，大伙明白就行了，多谢！

Snowict

Notes\r\n\r\n   1. The HSI/P supports 1MB through 32MB, 72-Pin, 5 Volt SIMMs.\r\n   2. A 4MB SIMM is installed as a standard configuration.\r\n   3. The 4MB SIMM does not have a Sun part number.\r\n   4. The BDM port is defined in the QUICC Users Manual, Section 9.9.\r\n   5. The HSI/P Cable provides four DB37 connectors.\r\n   6. The HSI/P is not supported on the PCI+ I/O assembly (540-6247) \r\n\r\nOperating System Notes\r\n\r\n   1. The minimum operating system is Solaris 2.5.1 Hardware: 4/97.\r\n   2. The HSI/P 1.0 software is on CD-ROM 704-5748-10.\r\n   3. The HSI/P 2.0 software is on CD-ROM 704-6439-10.\r\n   4. Option 1155 includes HSI/P 2.0 for Solaris 7.\r\n   5. The Solaris 8 Supplement includes HSI 3.0 software.\r\n   6. Solaris messaging identifies the card as \"pci1214,334\". \r\n\r\n\r\nHSI/P Cabling\r\nThe Sun HSI/P provides external connectivity through a passive cabling system. A “Hydra\r\nstyle” connector provides front panel serial port connectivity to four DB37 connectors for the\r\nRS-449 in DTE configuration (female connector).

fujitsu_solaris

1。装HSI驱动，\r\n2。装HSI patch\r\n3.装FRAME RELAY软件

maxtp

详细点好吗？那个连线是什么样的线？两头多少针的？sun可以定到？订货号？谢谢！

swallowcn

哪线我好象有一根，是从卡到哪个扩展板的哪个联接线吗?

maxtp

卡插在sun工作站上，然后连到基带猫上，猫是v35的接口，从卡到猫是什么样的线？能直接连？还需要接其他的设备吗？