做完POST后没有明显报错，但是有Board Descriptor (%o2): ffdfffff0bd11111

glfeng

hi，all\r\n \r\n今天我给E450检测，跟换备件，CPU FAN 和 DISK FAN，做POST时，有如下输出，请问是哪里有问题，谢谢\r\n\r\nNetwork Link Setup Failed. \r\nPlease Check Cable and Try Again. \r\nTimeout waiting for ARP/RARP packet\r\nSetting up Network Link and Speed. \r\nUsing Onboard Transceiver - Timeout waiting for AutoNegotiation Status to be updated. \r\nTimeout reading Link status. Check cable and try again. \r\nTimeout waiting for AutoNegotiation Status to be updated. \r\nTimeout reading Link status. Check cable and try again. \r\nTimeout waiting for AutoNegotiation Status to be updated. \r\nTimeout reading Link status. Check cable and try again. \r\nAutoNegotiation Timeout. \r\nCheck Cable or Contact your System Administrator. \r\nLink Down.\r\nNetwork Link Setup Failed. \r\nPlease Check Cable and Try Again. \r\nSetting up Network Link and Speed. \r\nUsing Onboard Transceiver - Timeout waiting for AutoNegotiation Status to be updated. \r\nTimeout reading Link status. Check cable and try again. \r\nTimeout waiting for AutoNegotiation Status to be updated. \r\nTimeout reading Link status. Check cable and try again. \r\nTimeout waiting for AutoNegotiation Status to be updated. \r\nTimeout reading Link status. Check cable and try again. \r\nAutoNegotiation Timeout. \r\nCheck Cable or Contact your System Administrator. \r\nLink Down.\r\nNetwork Link Setup Failed. \r\nPlease Check Cable and Try Again. \r\nTimeout waiting for ARP/RARP packet\r\nSetting up Network Link and Speed. \r\nUsing Onboard Transceiver - Timeout waiting for AutoNegotiation Status to be updated. \r\nTimeout reading Link status. Check cable and try again. \r\n\r\n{1} ok \r\n{1} ok \r\n{1} ok show-post-results\r\nPower On Selftest not run on last reset\r\nPersistent/saved POST results are: \r\nStatus 0=Pass, Non-Zero=Fail (%o0): 0 \r\nMessage String               (%o1): \r\nBoard Descriptor             (%o2): ffdfffff0bd11111 \r\n{1} ok

Snowict

从信息中没有看到明显的错误报告。 请先修改EEPROM参数再POST 机器。\r\ndiag-switch? true\r\nauto-boot? false\r\ndiag-level? max\r\n\r\npower-recycle the E450

glfeng

prom 几个参数我都该了，而且POST4，5遍都不行，是主办有问题么？

nimysun

tatus 0=Pass, Non-Zero=Fail (%o0): 0 \r\n\r\n返回值为0吧，\r\n你的硬件没有什么问题吧。